Blackfin: clarify relocation comment during init

People often ask questions about the init process and when things go
from flash to relocated base, so clarify the comments a bit.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

1 files changed, 7 insertions, 3 deletions

diff --git a/cpu/blackfin/start.S b/cpu/blackfin/start.S
index 8617c9852e..6c8def4816 100644
--- a/cpu/blackfin/start.S
+++ b/cpu/blackfin/start.S
@@ -125,9 +125,11 @@ ENTRY(_start)
 	 */
 	r6 = 1 (x);
 
-	/* Relocate from wherever are (FLASH/RAM/etc...) to the hardcoded
+	/* Relocate from wherever we are (FLASH/RAM/etc...) to the hardcoded
 	 * monitor location in the end of RAM.  We know that memcpy() only
-	 * uses registers, so it is safe to call here.
+	 * uses registers, so it is safe to call here.  Note that this only
+	 * copies to external memory ... we do not start executing out of
+	 * it yet (see "lower to 15" below).
 	 */
 	serial_early_puts("Relocate");
 	call _get_pc;
@@ -172,7 +174,9 @@ ENTRY(_start)
 	 * setting the 15 handler to ".Lenable_nested", raising the 15
 	 * interrupt, and then returning from the highest interrupt
 	 * level to the dummy "jump" until the interrupt controller
-	 * services the pending 15 interrupt.
+	 * services the pending 15 interrupt.  If executing out of
+	 * flash, these steps also changes the code flow from flash
+	 * to external memory.
 	 */
 	serial_early_puts("Lower to 15");
 	r0 = r7;