ram: stm32mp1: the property st, phy-cal becomes optional

This parameter "st,phy-cal" becomes optional and when it is
absent the built-in PHY calibration is done.

It is the case in the helper dtsi file "stm32mp15-ddr.dtsi"
except if DDR_PHY_CAL_SKIP is defined.

This patch also impact the ddr interactive mode
- the registers of the param 'phy.cal' are initialized to 0 when
  "st,phy-cal" is not present in device tree (default behavior when
  DDR_PHY_CAL_SKIP is not activated)
- the info 'cal' field can be use to change the calibration behavior
  - cal=1 => use param phy.cal to initialize the PHY, built-in training
             is skipped
  - cal=0 => param phy.cal is absent, built-in training is used (default)

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
Acked-by: Patrice Chotard <patrice.chotard@st.com>

1 files changed, 1 insertions, 0 deletions

diff --git a/drivers/ram/stm32mp1/stm32mp1_ddr.h b/drivers/ram/stm32mp1/stm32mp1_ddr.h
index 52b748f3ca..4998f04439 100644
--- a/drivers/ram/stm32mp1/stm32mp1_ddr.h
+++ b/drivers/ram/stm32mp1/stm32mp1_ddr.h
@@ -170,6 +170,7 @@ struct stm32mp1_ddr_config {
 	struct stm32mp1_ddrphy_reg p_reg;
 	struct stm32mp1_ddrphy_timing p_timing;
 	struct stm32mp1_ddrphy_cal p_cal;
+	bool p_cal_present;
 };
 
 int stm32mp1_ddr_clk_enable(struct ddr_info *priv, u32 mem_speed);