ARM: at91: remove non-generic boards

Remove board support for afeb9260, tny_a9260, and sbc35_a9g20.

They have not been converted into Generic Board yet.
See doc/README.generic-board for details.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Cc: Sergey Lapin <slapin@ossfans.org>
Cc: Albin Tonnerre <albin.tonnerre@free-electrons.com>
Cc: Andreas Bießmann <andreas.devel@googlemail.com>

1 files changed, 0 insertions, 150 deletions

diff --git a/include/configs/tny_a9260.h b/include/configs/tny_a9260.h
deleted file mode 100644
index 79c7fc5129..0000000000
--- a/include/configs/tny_a9260.h
+++ /dev/null
@@ -1,150 +0,0 @@
-/*
- * (C) Copyright 2007-2008
- * Stelian Pop <stelian@popies.net>
- * Lead Tech Design <www.leadtechdesign.com>
- *
- * Copyright (C) 2009
- * Albin Tonnerre, Free Electrons <albin.tonnerre@free-electrons.com>
- *
- * Configuation settings for the Calao TNY-A9260 and TNY-A9G20 boards
- *
- * SPDX-License-Identifier:	GPL-2.0+
- */
-
-#ifndef __CONFIG_H
-#define __CONFIG_H
-
-/*
- * SoC must be defined first, before hardware.h is included.
- * In this case SoC is defined in boards.cfg.
- */
-#include <asm/hardware.h>
-
-#if defined(CONFIG_TNY_A9260_NANDFLASH) || defined(CONFIG_TNY_A9G20_NANDFLASH)
-#define CONFIG_ENV_IS_IN_NAND
-#else
-#define CONFIG_ENV_IS_IN_EEPROM
-#endif
-
-/* Define actual evaluation board type from used processor type */
-#ifdef CONFIG_AT91SAM9G20
-# define CONFIG_TNY_A9G20
-# define MACH_TYPE_TNY_A9G20		2059
-# define CONFIG_MACH_TYPE		MACH_TYPE_TNY_A9G20
-#else
-# define CONFIG_TNY_A9260
-# define MACH_TYPE_TNY_A9260		2058
-# define CONFIG_MACH_TYPE		MACH_TYPE_TNY_A9260
-#endif
-
-/* ARM asynchronous clock */
-#define CONFIG_SYS_AT91_SLOW_CLOCK	32768		/* slow clock xtal */
-#define CONFIG_SYS_AT91_MAIN_CLOCK	12000000	/* 12 MHz crystal */
-
-#define CONFIG_ARCH_CPU_INIT
-#define CONFIG_CMDLINE_TAG	        /* enable passing of ATAGs	*/
-#define CONFIG_SETUP_MEMORY_TAGS
-#define CONFIG_INITRD_TAG
-#define CONFIG_SKIP_LOWLEVEL_INIT
-
-/*
- * Hardware drivers
- */
-#define CONFIG_ATMEL_LEGACY
-#define CONFIG_AT91_GPIO
-
-#define CONFIG_ATMEL_USART
-#define CONFIG_USART_BASE		ATMEL_BASE_DBGU
-#define	CONFIG_USART_ID			ATMEL_ID_SYS
-#define CONFIG_BAUDRATE			115200
-
-#define CONFIG_BOOTDELAY	3
-
-/*
- * Command line configuration.
- */
-#include <config_cmd_default.h>
-#undef CONFIG_CMD_BDI
-#undef CONFIG_CMD_FPGA
-#undef CONFIG_CMD_IMI
-#undef CONFIG_CMD_IMLS
-#undef CONFIG_CMD_LOADS
-#undef CONFIG_CMD_NET
-#undef CONFIG_CMD_NFS
-#undef CONFIG_CMD_SOURCE
-#undef CONFIG_CMD_USB
-
-/* SDRAM */
-#define CONFIG_NR_DRAM_BANKS		1
-#define CONFIG_SYS_SDRAM_BASE		ATMEL_BASE_CS1
-#define CONFIG_SYS_SDRAM_SIZE		0x04000000	/* 64 megs */
-# define CONFIG_SYS_INIT_SP_ADDR \
-	(ATMEL_BASE_SRAM1 + 0x1000 - GENERATED_GBL_DATA_SIZE)
-
-/* SPI EEPROM */
-#define CONFIG_SPI
-#define CONFIG_CMD_SPI
-#define CONFIG_ATMEL_SPI
-
-#define CONFIG_CMD_EEPROM
-#define CONFIG_SPI_M95XXX
-#define CONFIG_SYS_EEPROM_SIZE 0x10000
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 5
-
-/* NAND flash */
-#define CONFIG_CMD_NAND
-#define CONFIG_NAND_ATMEL
-#define CONFIG_SYS_MAX_NAND_DEVICE		1
-#define CONFIG_SYS_NAND_BASE			ATMEL_BASE_CS3
-#define CONFIG_SYS_NAND_DBW_8
-/* our ALE is AD21 */
-#define CONFIG_SYS_NAND_MASK_ALE		(1 << 21)
-/* our CLE is AD22 */
-#define CONFIG_SYS_NAND_MASK_CLE		(1 << 22)
-#define CONFIG_SYS_NAND_ENABLE_PIN		AT91_PIN_PC14
-#define CONFIG_SYS_NAND_READY_PIN		AT91_PIN_PC13
-
-/* NOR flash - no real flash on this board */
-#define CONFIG_SYS_NO_FLASH
-
-#define CONFIG_DOS_PARTITION
-#define CONFIG_CMD_FAT
-
-#define CONFIG_SYS_LOAD_ADDR			0x22000000	/* load address */
-
-#define CONFIG_SYS_MEMTEST_START		CONFIG_SYS_SDRAM_BASE
-#define CONFIG_SYS_MEMTEST_END			0x23e00000
-
-/* Env in EEPROM, bootstrap + u-boot in NAND*/
-#ifdef CONFIG_ENV_IS_IN_EEPROM
-#define CONFIG_ENV_OFFSET		0x20
-#define CONFIG_ENV_SIZE		        0x1000
-#endif
-
-/* Env, bootstrap and u-boot in NAND */
-#ifdef CONFIG_ENV_IS_IN_NAND
-#define CONFIG_ENV_OFFSET               0x60000
-#define CONFIG_ENV_OFFSET_REDUND        0x80000
-#define CONFIG_ENV_SIZE                 0x20000
-#endif
-
-#define CONFIG_BOOTCOMMAND	"nboot 0x21000000 0 400000"
-#define CONFIG_BOOTARGS		"console=ttyS0,115200 " \
-				"root=/dev/mtdblock1 " \
-				"mtdparts=atmel_nand:16M(kernel)ro," \
-				"120M(rootfs),-(other) " \
-				"rw rootfstype=jffs2"
-
-#define CONFIG_SYS_PROMPT	"U-Boot> "
-#define CONFIG_SYS_CBSIZE	256
-#define CONFIG_SYS_MAXARGS	16
-#define CONFIG_SYS_PBSIZE	(CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)
-#define CONFIG_SYS_LONGHELP
-#define CONFIG_CMDLINE_EDITING
-
-/*
- * Size of malloc() pool
- */
-#define CONFIG_SYS_MALLOC_LEN	ROUND(3 * CONFIG_ENV_SIZE + 128 * 1024, 0x1000)
-
-#endif