Change initdram() return type to phys_size_t

This patch changes the return type of initdram() from long int to phys_size_t.
This is required for a couple of reasons: long int limits the amount of dram
to 2GB, and u-boot in general is moving over to phys_size_t to represent the
size of physical memory.  phys_size_t is defined as an unsigned long on almost
all current platforms.

This patch *only* changes the return type of the initdram function (in
include/common.h, as well as in each board's implementation of initdram).  It
does not actually modify the code inside the function on any of the platforms;
platforms which wish to support more than 2GB of DRAM will need to modify
their initdram() function code.

Build tested with MAKEALL for ppc, arm, mips, mips-el. Booted on powerpc
MPC8641HPCN.

Signed-off-by: Becky Bruce <becky.bruce@freescale.com>

1 files changed, 2 insertions, 2 deletions

diff --git a/nand_spl/board/amcc/bamboo/sdram.c b/nand_spl/board/amcc/bamboo/sdram.c
index ca25252edf..adede44c37 100644
--- a/nand_spl/board/amcc/bamboo/sdram.c
+++ b/nand_spl/board/amcc/bamboo/sdram.c
@@ -36,7 +36,7 @@ static void wait_init_complete(void)
 }
 
 /*
- * long int initdram(int board_type)
+ * phys_size_t initdram(int board_type)
  *
  * As the name already indicates, this function is called very early
  * from start.S and configures the SDRAM with fixed values. This is needed,
@@ -51,7 +51,7 @@ static void wait_init_complete(void)
  * modules are still plugged in. So it is recommended to remove the DIMM
  * modules while using the NAND booting code with the fixed SDRAM setup!
  */
-long int initdram(int board_type)
+phys_size_t initdram(int board_type)
 {
 	/*
 	 * Soft-reset SDRAM controller.