diff options
| -rw-r--r-- | board/ronetix/pm9263/pm9263.c | 93 | ||||
| -rw-r--r-- | configs/pm9263_defconfig | 3 |
2 files changed, 3 insertions, 93 deletions
diff --git a/board/ronetix/pm9263/pm9263.c b/board/ronetix/pm9263/pm9263.c index 692288d52e..2da39c4acd 100644 --- a/board/ronetix/pm9263/pm9263.c +++ b/board/ronetix/pm9263/pm9263.c @@ -17,8 +17,6 @@ #include <asm/arch/at91_matrix.h> #include <asm/arch/clk.h> #include <asm/arch/gpio.h> -#include <lcd.h> -#include <atmel_lcdc.h> #if defined(CONFIG_RESET_PHY_R) && defined(CONFIG_MACB) #include <net.h> #endif @@ -109,32 +107,6 @@ static void pm9263_macb_hw_init(void) #endif #ifdef CONFIG_LCD -vidinfo_t panel_info = { - .vl_col = 240, - .vl_row = 320, - .vl_clk = 4965000, - .vl_sync = ATMEL_LCDC_INVLINE_INVERTED | - ATMEL_LCDC_INVFRAME_INVERTED, - .vl_bpix = 3, - .vl_tft = 1, - .vl_hsync_len = 5, - .vl_left_margin = 1, - .vl_right_margin = 33, - .vl_vsync_len = 1, - .vl_upper_margin = 1, - .vl_lower_margin = 0, - .mmio = ATMEL_BASE_LCDC, -}; - -void lcd_enable(void) -{ - at91_set_pio_value(AT91_PIO_PORTA, 22, 1); /* power up */ -} - -void lcd_disable(void) -{ - at91_set_pio_value(AT91_PIO_PORTA, 22, 0); /* power down */ -} #ifdef CONFIG_LCD_IN_PSRAM @@ -226,32 +198,6 @@ static int pm9263_lcd_hw_psram_init(void) static void pm9263_lcd_hw_init(void) { - at91_set_a_periph(AT91_PIO_PORTC, 0, 0); /* LCDVSYNC */ - at91_set_a_periph(AT91_PIO_PORTC, 1, 0); /* LCDHSYNC */ - at91_set_a_periph(AT91_PIO_PORTC, 2, 0); /* LCDDOTCK */ - at91_set_a_periph(AT91_PIO_PORTC, 3, 0); /* LCDDEN */ - at91_set_b_periph(AT91_PIO_PORTB, 9, 0); /* LCDCC */ - at91_set_a_periph(AT91_PIO_PORTC, 6, 0); /* LCDD2 */ - at91_set_a_periph(AT91_PIO_PORTC, 7, 0); /* LCDD3 */ - at91_set_a_periph(AT91_PIO_PORTC, 8, 0); /* LCDD4 */ - at91_set_a_periph(AT91_PIO_PORTC, 9, 0); /* LCDD5 */ - at91_set_a_periph(AT91_PIO_PORTC, 10, 0); /* LCDD6 */ - at91_set_a_periph(AT91_PIO_PORTC, 11, 0); /* LCDD7 */ - at91_set_a_periph(AT91_PIO_PORTC, 14, 0); /* LCDD10 */ - at91_set_a_periph(AT91_PIO_PORTC, 15, 0); /* LCDD11 */ - at91_set_a_periph(AT91_PIO_PORTC, 16, 0); /* LCDD12 */ - at91_set_b_periph(AT91_PIO_PORTC, 12, 0); /* LCDD13 */ - at91_set_a_periph(AT91_PIO_PORTC, 18, 0); /* LCDD14 */ - at91_set_a_periph(AT91_PIO_PORTC, 19, 0); /* LCDD15 */ - at91_set_a_periph(AT91_PIO_PORTC, 22, 0); /* LCDD18 */ - at91_set_a_periph(AT91_PIO_PORTC, 23, 0); /* LCDD19 */ - at91_set_a_periph(AT91_PIO_PORTC, 24, 0); /* LCDD20 */ - at91_set_b_periph(AT91_PIO_PORTC, 17, 0); /* LCDD21 */ - at91_set_a_periph(AT91_PIO_PORTC, 26, 0); /* LCDD22 */ - at91_set_a_periph(AT91_PIO_PORTC, 27, 0); /* LCDD23 */ - - at91_periph_clk_enable(ATMEL_ID_LCDC); - /* Power Control */ at91_set_pio_output(AT91_PIO_PORTA, 22, 1); at91_set_pio_value(AT91_PIO_PORTA, 22, 0); /* power down */ @@ -267,45 +213,6 @@ static void pm9263_lcd_hw_init(void) } -#ifdef CONFIG_LCD_INFO -#include <nand.h> -#include <version.h> - -extern flash_info_t flash_info[]; - -void lcd_show_board_info(void) -{ - ulong dram_size, nand_size, flash_size; - int i; - char temp[32]; - - lcd_printf ("%s\n", U_BOOT_VERSION); - lcd_printf ("(C) 2009 Ronetix GmbH\n"); - lcd_printf ("support@ronetix.at\n"); - lcd_printf ("%s CPU at %s MHz", - CONFIG_SYS_AT91_CPU_NAME, - strmhz(temp, get_cpu_clk_rate())); - - dram_size = 0; - for (i = 0; i < CONFIG_NR_DRAM_BANKS; i++) - dram_size += gd->bd->bi_dram[i].size; - - nand_size = 0; - for (i = 0; i < CONFIG_SYS_MAX_NAND_DEVICE; i++) - nand_size += get_nand_dev_by_index(i)->size; - - flash_size = 0; - for (i = 0; i < CONFIG_SYS_MAX_FLASH_BANKS; i++) - flash_size += flash_info[i].size; - - lcd_printf ("%ld MB SDRAM, %ld MB NAND\n%ld MB NOR Flash\n" - "4 MB PSRAM\n", - dram_size >> 20, - nand_size >> 20, - flash_size >> 20); -} -#endif /* CONFIG_LCD_INFO */ - #endif /* CONFIG_LCD */ int board_early_init_f(void) diff --git a/configs/pm9263_defconfig b/configs/pm9263_defconfig index 1c948b2ce5..3ab535ffb0 100644 --- a/configs/pm9263_defconfig +++ b/configs/pm9263_defconfig @@ -33,6 +33,7 @@ CONFIG_DEFAULT_DEVICE_TREE="at91sam9263ek" CONFIG_ENV_IS_IN_FLASH=y CONFIG_ENV_SECT_SIZE=0x10000 CONFIG_DM=y +CONFIG_BLK=y CONFIG_CLK=y CONFIG_CLK_AT91=y CONFIG_DM_GPIO=y @@ -52,5 +53,7 @@ CONFIG_ATMEL_USART=y CONFIG_SPI=y CONFIG_DM_SPI=y CONFIG_USB=y +CONFIG_DM_USB=y CONFIG_USB_STORAGE=y CONFIG_LCD=y +CONFIG_DM_VIDEO=y |