diff options
| -rw-r--r-- | board/amcc/bamboo/bamboo.c | 4 | ||||
| -rw-r--r-- | nand_spl/board/amcc/bamboo/sdram.c | 6 |
2 files changed, 8 insertions, 2 deletions
diff --git a/board/amcc/bamboo/bamboo.c b/board/amcc/bamboo/bamboo.c index 00c793afd0..c4eace5804 100644 --- a/board/amcc/bamboo/bamboo.c +++ b/board/amcc/bamboo/bamboo.c @@ -67,13 +67,13 @@ const unsigned char cfg_simulate_spd_eeprom[128] = { 0x00, /* Module data width continued: +0 */ 0x04, /* 2.5 Volt */ 0x75, /* SDRAM Cycle Time (cas latency 2.5) = 7.5 ns */ + 0x00, /* SDRAM Access from clock */ #ifdef CONFIG_DDR_ECC 0x02, /* ECC ON : 02 OFF : 00 */ #else 0x00, /* ECC ON : 02 OFF : 00 */ #endif - 0x82, /* refresh Rate Type: Normal (15.625us) + Self refresh */ - 0, + 0x82, /* refresh Rate Type: Normal (7.8us) + Self refresh */ 0, 0, 0x01, /* wcsbc = 1 */ diff --git a/nand_spl/board/amcc/bamboo/sdram.c b/nand_spl/board/amcc/bamboo/sdram.c index 4f09072df0..ac77d066cb 100644 --- a/nand_spl/board/amcc/bamboo/sdram.c +++ b/nand_spl/board/amcc/bamboo/sdram.c @@ -44,6 +44,12 @@ static void wait_init_complete(void) * not enough free space to implement the complete I2C SPD DDR autodetection * routines. Therefore the Bamboo only supports the onboard 64MBytes of SDRAM * when booting from NAND flash. + * + * Note: + * As found out by Eugene O'Brien <eugene.obrien@advantechamt.com>, the fixed + * DDR setup has problems (U-Boot crashes randomly upon TFTP), when the DIMM + * modules are still plugged in. So it is recommended to remove the DIMM + * modules while using the NAND booting code with the fixed SDRAM setup! */ void early_sdram_init(void) { |