diff options
Diffstat (limited to 'arch/arm/include/asm/arch-omap5')
| -rw-r--r-- | arch/arm/include/asm/arch-omap5/clocks.h | 1 | ||||
| -rw-r--r-- | arch/arm/include/asm/arch-omap5/omap.h | 16 | ||||
| -rw-r--r-- | arch/arm/include/asm/arch-omap5/sys_proto.h | 18 |
3 files changed, 27 insertions, 8 deletions
diff --git a/arch/arm/include/asm/arch-omap5/clocks.h b/arch/arm/include/asm/arch-omap5/clocks.h index edcc9e9364..fa99f654bd 100644 --- a/arch/arm/include/asm/arch-omap5/clocks.h +++ b/arch/arm/include/asm/arch-omap5/clocks.h @@ -708,6 +708,7 @@ void setup_post_dividers(u32 *const base, const struct dpll_params *params); u32 get_sys_clk_index(void); void enable_basic_clocks(void); void enable_non_essential_clocks(void); +void enable_basic_uboot_clocks(void); void do_enable_clocks(u32 *const *clk_domains, u32 *const *clk_modules_hw_auto, u32 *const *clk_modules_explicit_en, diff --git a/arch/arm/include/asm/arch-omap5/omap.h b/arch/arm/include/asm/arch-omap5/omap.h index 85975de2da..d811d6ec23 100644 --- a/arch/arm/include/asm/arch-omap5/omap.h +++ b/arch/arm/include/asm/arch-omap5/omap.h @@ -203,5 +203,21 @@ struct control_lpddr2io_regs { #define DEV_DESC_PTR_OFFSET 0x4 #define DEV_DATA_PTR_OFFSET 0x18 #define BOOT_MODE_OFFSET 0x8 +#define RESET_REASON_OFFSET 0x9 +#define CH_FLAGS_OFFSET 0xA +#define CH_FLAGS_CHSETTINGS (0x1 << 0) +#define CH_FLAGS_CHRAM (0x1 << 1) +#define CH_FLAGS_CHFLASH (0x1 << 2) +#define CH_FLAGS_CHMMCSD (0x1 << 3) + +#ifndef __ASSEMBLY__ +struct omap_boot_parameters { + char *boot_message; + unsigned int mem_boot_descriptor; + unsigned char omap_bootdevice; + unsigned char reset_reason; + unsigned char ch_flags; +}; +#endif /* __ASSEMBLY__ */ #endif diff --git a/arch/arm/include/asm/arch-omap5/sys_proto.h b/arch/arm/include/asm/arch-omap5/sys_proto.h index 3803ea9f55..c31e18ca22 100644 --- a/arch/arm/include/asm/arch-omap5/sys_proto.h +++ b/arch/arm/include/asm/arch-omap5/sys_proto.h @@ -75,15 +75,17 @@ static inline u32 running_from_sdram(void) static inline u8 uboot_loaded_by_spl(void) { /* - * Configuration Header is not supported yet, so u-boot init running - * from SDRAM implies that it was loaded by SPL. When this situation - * changes one of these approaches could be taken: - * i. Pass a magic from SPL to U-Boot and U-Boot save it at a known - * location. - * ii. Check the OPP. CH can support only 50% OPP while SPL initializes - * the DPLLs at 100% OPP. + * u-boot can be running from sdram either because of configuration + * Header or by SPL. If because of CH, then the romcode sets the + * CHSETTINGS executed bit to true in the boot parameter structure that + * it passes to the bootloader.This parameter is stored in the ch_flags + * variable by both SPL and u-boot.Check out for CHSETTINGS, which is a + * mandatory section if CH is present. */ - return running_from_sdram(); + if ((boot_params.ch_flags) & (CH_FLAGS_CHSETTINGS)) + return 0; + else + return running_from_sdram(); } /* * The basic hardware init of OMAP(s_init()) can happen in 4 |