diff options
Diffstat (limited to 'board/Marvell/db64360')
-rw-r--r-- | board/Marvell/db64360/mpsc.c | 2 | ||||
-rw-r--r-- | board/Marvell/db64360/mpsc.h | 6 | ||||
-rw-r--r-- | board/Marvell/db64360/mv_eth.c | 62 | ||||
-rw-r--r-- | board/Marvell/db64360/u-boot.lds | 8 |
4 files changed, 39 insertions, 39 deletions
diff --git a/board/Marvell/db64360/mpsc.c b/board/Marvell/db64360/mpsc.c index d8acd31953..923d95555b 100644 --- a/board/Marvell/db64360/mpsc.c +++ b/board/Marvell/db64360/mpsc.c @@ -425,7 +425,7 @@ void mpsc_sdma_init (void) (MV64360_SDMA_WIN_ACCESS_FULL << (MV64360_CUNIT_BASE_ADDR_WIN_0_BIT * 2))); -/* Setup MPSC internal address space base address */ +/* Setup MPSC internal address space base address */ GT_REG_WRITE (CUNIT_INTERNAL_SPACE_BASE_ADDR_REG, CFG_GT_REGS); /* no high address remap*/ diff --git a/board/Marvell/db64360/mpsc.h b/board/Marvell/db64360/mpsc.h index f95f8c0f47..4b537eadc4 100644 --- a/board/Marvell/db64360/mpsc.h +++ b/board/Marvell/db64360/mpsc.h @@ -67,9 +67,9 @@ extern int (*mpsc_test_char)(void); #define TX_STOP 0x00010000 #define RX_ENABLE 0x00000080 -#define SDMA_RX_ABORT (1 << 15) -#define SDMA_TX_ABORT (1 << 31) -#define MPSC_TX_ABORT (1 << 7) +#define SDMA_RX_ABORT (1 << 15) +#define SDMA_TX_ABORT (1 << 31) +#define MPSC_TX_ABORT (1 << 7) #define MPSC_RX_ABORT (1 << 23) #define MPSC_ENTER_HUNT (1 << 31) diff --git a/board/Marvell/db64360/mv_eth.c b/board/Marvell/db64360/mv_eth.c index e5a87ad295..dfc0bf7d30 100644 --- a/board/Marvell/db64360/mv_eth.c +++ b/board/Marvell/db64360/mv_eth.c @@ -1391,7 +1391,7 @@ u32 mv_get_internal_sram_base (void) * port_phy_addr). * * INPUT: -* ETH_PORT_INFO *p_eth_port_ctrl Ethernet port control struct +* ETH_PORT_INFO *p_eth_port_ctrl Ethernet port control struct * * OUTPUT: * See description. @@ -1551,7 +1551,7 @@ static void eth_port_init (ETH_PORT_INFO * p_eth_port_ctrl) * ether_init_rx_desc_ring for Rx queues). * * INPUT: -* ETH_PORT_INFO *p_eth_port_ctrl Ethernet port control struct +* ETH_PORT_INFO *p_eth_port_ctrl Ethernet port control struct * * OUTPUT: * Ethernet port is ready to receive and transmit. @@ -1641,7 +1641,7 @@ static bool eth_port_start (ETH_PORT_INFO * p_eth_port_ctrl) * INPUT: * ETH_PORT eth_port_num Port number. * char * p_addr Address to be set -* ETH_QUEUE queue Rx queue number for this MAC address. +* ETH_QUEUE queue Rx queue number for this MAC address. * * OUTPUT: * Set MAC address low and high registers. also calls eth_port_uc_addr() @@ -1679,10 +1679,10 @@ static void eth_port_uc_addr_set (ETH_PORT eth_port_num, * parameters. * * INPUT: -* ETH_PORT eth_port_num Port number. +* ETH_PORT eth_port_num Port number. * unsigned char uc_nibble Unicast MAC Address last nibble. -* ETH_QUEUE queue Rx queue number for this MAC address. -* int option 0 = Add, 1 = remove address. +* ETH_QUEUE queue Rx queue number for this MAC address. +* int option 0 = Add, 1 = remove address. * * OUTPUT: * This function add/removes MAC addresses from the port unicast address @@ -1761,10 +1761,10 @@ static bool eth_port_uc_addr (ETH_PORT eth_port_num, * In this case, the function calculates the CRC-8bit value and calls * eth_port_omc_addr() routine to set the Other Multicast Table. * INPUT: -* ETH_PORT eth_port_num Port number. -* unsigned char *p_addr Unicast MAC Address. -* ETH_QUEUE queue Rx queue number for this MAC address. -* int option 0 = Add, 1 = remove address. +* ETH_PORT eth_port_num Port number. +* unsigned char *p_addr Unicast MAC Address. +* ETH_QUEUE queue Rx queue number for this MAC address. +* int option 0 = Add, 1 = remove address. * * OUTPUT: * See description. @@ -1895,10 +1895,10 @@ static void eth_port_mc_addr (ETH_PORT eth_port_num, * according to the argument given. * * INPUT: -* ETH_PORT eth_port_num Port number. -* unsigned char mc_byte Multicast addr last byte (MAC DA[7:0] bits). -* ETH_QUEUE queue Rx queue number for this MAC address. -* int option 0 = Add, 1 = remove address. +* ETH_PORT eth_port_num Port number. +* unsigned char mc_byte Multicast addr last byte (MAC DA[7:0] bits). +* ETH_QUEUE queue Rx queue number for this MAC address. +* int option 0 = Add, 1 = remove address. * * OUTPUT: * See description. @@ -1959,10 +1959,10 @@ static bool eth_port_smc_addr (ETH_PORT eth_port_num, * CRC-8 argument given. * * INPUT: -* ETH_PORT eth_port_num Port number. -* unsigned char crc8 A CRC-8bit (Polynomial: x^8+x^2+x^1+1). -* ETH_QUEUE queue Rx queue number for this MAC address. -* int option 0 = Add, 1 = remove address. +* ETH_PORT eth_port_num Port number. +* unsigned char crc8 A CRC-8bit (Polynomial: x^8+x^2+x^1+1). +* ETH_QUEUE queue Rx queue number for this MAC address. +* int option 0 = Add, 1 = remove address. * * OUTPUT: * See description. @@ -2203,7 +2203,7 @@ static bool ethernet_phy_reset (ETH_PORT eth_port_num) * eth_port_reset - Reset Ethernet port * * DESCRIPTION: - * This routine resets the chip by aborting any SDMA engine activity and + * This routine resets the chip by aborting any SDMA engine activity and * clearing the MIB counters. The Receiver and the Transmit unit are in * idle state after this command is performed and the port is disabled. * @@ -2556,9 +2556,9 @@ static void eth_set_access_control (ETH_PORT eth_port_num, * * INPUT: * ETH_PORT_INFO *p_eth_port_ctrl Ethernet Port Control srtuct. - * ETH_QUEUE rx_queue Number of Rx queue. - * int rx_desc_num Number of Rx descriptors - * int rx_buff_size Size of Rx buffer + * ETH_QUEUE rx_queue Number of Rx queue. + * int rx_desc_num Number of Rx descriptors + * int rx_buff_size Size of Rx buffer * unsigned int rx_desc_base_addr Rx descriptors memory area base addr. * unsigned int rx_buff_base_addr Rx buffer memory area base addr. * @@ -2650,9 +2650,9 @@ static bool ether_init_rx_desc_ring (ETH_PORT_INFO * p_eth_port_ctrl, * * INPUT: * ETH_PORT_INFO *p_eth_port_ctrl Ethernet Port Control srtuct. - * ETH_QUEUE tx_queue Number of Tx queue. - * int tx_desc_num Number of Tx descriptors - * int tx_buff_size Size of Tx buffer + * ETH_QUEUE tx_queue Number of Tx queue. + * int tx_desc_num Number of Tx descriptors + * int tx_buff_size Size of Tx buffer * unsigned int tx_desc_base_addr Tx descriptors memory area base addr. * unsigned int tx_buff_base_addr Tx buffer memory area base addr. * @@ -2745,7 +2745,7 @@ static bool ether_init_tx_desc_ring (ETH_PORT_INFO * p_eth_port_ctrl, * * INPUT: * ETH_PORT_INFO *p_eth_port_ctrl Ethernet Port Control srtuct. - * ETH_QUEUE tx_queue Number of Tx queue. + * ETH_QUEUE tx_queue Number of Tx queue. * PKT_INFO *p_pkt_info User packet buffer. * * OUTPUT: @@ -2861,7 +2861,7 @@ static ETH_FUNC_RET_STATUS eth_port_send (ETH_PORT_INFO * p_eth_port_ctrl, * * INPUT: * ETH_PORT_INFO *p_eth_port_ctrl Ethernet Port Control srtuct. - * ETH_QUEUE tx_queue Number of Tx queue. + * ETH_QUEUE tx_queue Number of Tx queue. * PKT_INFO *p_pkt_info User packet buffer. * * OUTPUT: @@ -2930,7 +2930,7 @@ static ETH_FUNC_RET_STATUS eth_tx_return_desc (ETH_PORT_INFO * * eth_port_receive - Get received information from Rx ring. * * DESCRIPTION: - * This routine returns the received data to the caller. There is no + * This routine returns the received data to the caller. There is no * data copying during routine operation. All information is returned * using pointer to packet information struct passed from the caller. * If the routine exhausts Rx ring resources then the resource error flag @@ -2938,7 +2938,7 @@ static ETH_FUNC_RET_STATUS eth_tx_return_desc (ETH_PORT_INFO * * * INPUT: * ETH_PORT_INFO *p_eth_port_ctrl Ethernet Port Control srtuct. - * ETH_QUEUE rx_queue Number of Rx queue. + * ETH_QUEUE rx_queue Number of Rx queue. * PKT_INFO *p_pkt_info User packet buffer. * * OUTPUT: @@ -2980,7 +2980,7 @@ static ETH_FUNC_RET_STATUS eth_port_receive (ETH_PORT_INFO * p_eth_port_ctrl, /* Nothing to receive... */ if (command_status & (ETH_BUFFER_OWNED_BY_DMA)) { -/* DP(printf("Rx: command_status: %08x\n", command_status)); */ +/* DP(printf("Rx: command_status: %08x\n", command_status)); */ D_CACHE_FLUSH_LINE ((unsigned int) p_rx_curr_desc, 0); /* DP(printf("\nETH_END_OF_JOB ...\n"));*/ return ETH_END_OF_JOB; @@ -3019,7 +3019,7 @@ static ETH_FUNC_RET_STATUS eth_port_receive (ETH_PORT_INFO * p_eth_port_ctrl, * * INPUT: * ETH_PORT_INFO *p_eth_port_ctrl Ethernet Port Control srtuct. - * ETH_QUEUE rx_queue Number of Rx queue. + * ETH_QUEUE rx_queue Number of Rx queue. * PKT_INFO *p_pkt_info Information on the returned buffer. * * OUTPUT: diff --git a/board/Marvell/db64360/u-boot.lds b/board/Marvell/db64360/u-boot.lds index 25e16de3b6..1a95755ab4 100644 --- a/board/Marvell/db64360/u-boot.lds +++ b/board/Marvell/db64360/u-boot.lds @@ -37,11 +37,11 @@ SECTIONS .dynsym : { *(.dynsym) } .dynstr : { *(.dynstr) } .rel.text : { *(.rel.text) } - .rela.text : { *(.rela.text) } + .rela.text : { *(.rela.text) } .rel.data : { *(.rel.data) } - .rela.data : { *(.rela.data) } - .rel.rodata : { *(.rel.rodata) } - .rela.rodata : { *(.rela.rodata) } + .rela.data : { *(.rela.data) } + .rel.rodata : { *(.rel.rodata) } + .rela.rodata : { *(.rela.rodata) } .rel.got : { *(.rel.got) } .rela.got : { *(.rela.got) } .rel.ctors : { *(.rel.ctors) } |