diff options
Diffstat (limited to 'board/delta/delta.c')
| -rw-r--r-- | board/delta/delta.c | 37 |
1 files changed, 19 insertions, 18 deletions
diff --git a/board/delta/delta.c b/board/delta/delta.c index 68c39d23ce..df23076a64 100644 --- a/board/delta/delta.c +++ b/board/delta/delta.c @@ -28,6 +28,7 @@ #include <malloc.h> #include <command.h> #include <asm/arch/pxa-regs.h> +#include <asm/io.h> DECLARE_GLOBAL_DATA_PTR; @@ -110,7 +111,7 @@ static uchar kbd_command_prefix[] = "key_cmd"; static void get_pressed_keys(uchar *s) { unsigned long val; - val = GPLR3; + val = readl(GPLR3); if(val & (1<<31)) *s++ = KEYBD_KP_DKIN0; @@ -124,18 +125,18 @@ static void get_pressed_keys(uchar *s) static void keys_init() { - CKENB |= CKENB_7_GPIO; + writel(readl(CKENB) | CKENB_7_GPIO, CKENB); udelay(100); /* Configure GPIOs */ - GPIO127 = 0xa840; /* KP_DKIN0 */ - GPIO114 = 0xa840; /* KP_DKIN1 */ - GPIO125 = 0xa840; /* KP_DKIN2 */ - GPIO118 = 0xa840; /* KP_DKIN5 */ + writel(0xa840, GPIO127); /* KP_DKIN0 */ + writel(0xa840, GPIO114); /* KP_DKIN1 */ + writel(0xa840, GPIO125); /* KP_DKIN2 */ + writel(0xa840, GPIO118); /* KP_DKIN5 */ /* Configure GPIOs as inputs */ - GPDR3 &= ~(1<<31 | 1<<18 | 1<<29 | 1<<22); - GCDR3 = (1<<31 | 1<<18 | 1<<29 | 1<<22); + writel(readl(GPDR3) & ~(1<<31 | 1<<18 | 1<<29 | 1<<22), GPDR3); + writel((1<<31 | 1<<18 | 1<<29 | 1<<22), GCDR3); udelay(100); } @@ -283,11 +284,11 @@ int dram_init (void) void i2c_init_board() { - CKENB |= (CKENB_4_I2C); + writel(readl(CKENB) | (CKENB_4_I2C), CKENB); /* setup I2C GPIO's */ - GPIO32 = 0x801; /* SCL = Alt. Fkt. 1 */ - GPIO33 = 0x801; /* SDA = Alt. Fkt. 1 */ + writel(0x801, GPIO32); /* SCL = Alt. Fkt. 1 */ + writel(0x801, GPIO33); /* SDA = Alt. Fkt. 1 */ } /* initialize the DA9030 Power Controller */ @@ -295,20 +296,20 @@ static void init_DA9030() { uchar addr = (uchar) DA9030_I2C_ADDR, val = 0; - CKENB |= CKENB_7_GPIO; + writel(readl(CKENB) | CKENB_7_GPIO, CKENB); udelay(100); /* Rising Edge on EXTON to reset DA9030 */ - GPIO17 = 0x8800; /* configure GPIO17, no pullup, -down */ - GPDR0 |= (1<<17); /* GPIO17 is output */ - GSDR0 = (1<<17); - GPCR0 = (1<<17); /* drive GPIO17 low */ - GPSR0 = (1<<17); /* drive GPIO17 high */ + writel(0x8800, GPIO17); /* configure GPIO17, no pullup, -down */ + writel(readl(GPDR0) | (1<<17), GPDR0); /* GPIO17 is output */ + writel((1<<17), GSDR0); + writel((1<<17), GPCR0); /* drive GPIO17 low */ + writel((1<<17), GPSR0); /* drive GPIO17 high */ #if CONFIG_SYS_DA9030_EXTON_DELAY udelay((unsigned long) CONFIG_SYS_DA9030_EXTON_DELAY); /* wait for DA9030 */ #endif - GPCR0 = (1<<17); /* drive GPIO17 low */ + writel((1<<17), GPCR0); /* drive GPIO17 low */ /* reset the watchdog and go active (0xec) */ val = (SYS_CONTROL_A_HWRES_ENABLE | |