diff options
Diffstat (limited to 'board/esd/cms700/cms700.c')
| -rw-r--r-- | board/esd/cms700/cms700.c | 39 |
1 files changed, 8 insertions, 31 deletions
diff --git a/board/esd/cms700/cms700.c b/board/esd/cms700/cms700.c index 635ba2fdb9..2cdd7be360 100644 --- a/board/esd/cms700/cms700.c +++ b/board/esd/cms700/cms700.c @@ -1,5 +1,5 @@ /* - * (C) Copyright 2005 + * (C) Copyright 2005-2007 * Matthias Fuchs, esd gmbh germany, matthias.fuchs@esd-electronics.com * * See file CREDITS for list of people who contributed to this @@ -23,6 +23,7 @@ #include <common.h> #include <asm/processor.h> +#include <asm/io.h> #include <command.h> #include <malloc.h> @@ -68,9 +69,9 @@ int board_early_init_f (void) /* * Reset CPLD via GPIO12 (CS3) pin */ - out32(GPIO0_OR, in32(GPIO0_OR) & ~CFG_PLD_RESET); + out_be32((void *)GPIO0_OR, in_be32((void *)GPIO0_OR) & ~CFG_PLD_RESET); udelay(1000); /* wait 1ms */ - out32(GPIO0_OR, in32(GPIO0_OR) | CFG_PLD_RESET); + out_be32((void *)GPIO0_OR, in_be32((void *)GPIO0_OR) | CFG_PLD_RESET); udelay(1000); /* wait 1ms */ return 0; @@ -94,13 +95,7 @@ int misc_init_r (void) /* * Setup and enable EEPROM write protection */ - out32(GPIO0_OR, in32(GPIO0_OR) | CFG_EEPROM_WP); - - /* - * Set NAND-FLASH GPIO signals to default - */ - out32(GPIO0_OR, in32(GPIO0_OR) & ~(CFG_NAND_CLE | CFG_NAND_ALE)); - out32(GPIO0_OR, in32(GPIO0_OR) | CFG_NAND_CE); + out_be32((void *)GPIO0_OR, in_be32((void *)GPIO0_OR) | CFG_EEPROM_WP); return (0); } @@ -153,11 +148,6 @@ long int initdram (int board_type) mtdcr(memcfga, mem_mb0cf); val = mfdcr(memcfgd); -#if 0 - printf("\nmb0cf=%x\n", val); /* test-only */ - printf("strap=%x\n", mfdcr(strap)); /* test-only */ -#endif - return (4*1024*1024 << ((val & 0x000e0000) >> 17)); } @@ -180,17 +170,17 @@ int eeprom_write_enable (unsigned dev_addr, int state) switch (state) { case 1: /* Enable write access, clear bit GPIO_SINT2. */ - out32(GPIO0_OR, in32(GPIO0_OR) & ~CFG_EEPROM_WP); + out_be32((void *)GPIO0_OR, in_be32((void *)GPIO0_OR) & ~CFG_EEPROM_WP); state = 0; break; case 0: /* Disable write access, set bit GPIO_SINT2. */ - out32(GPIO0_OR, in32(GPIO0_OR) | CFG_EEPROM_WP); + out_be32((void *)GPIO0_OR, in_be32((void *)GPIO0_OR) | CFG_EEPROM_WP); state = 0; break; default: /* Read current status back. */ - state = (0 == (in32(GPIO0_OR) & CFG_EEPROM_WP)); + state = (0 == (in_be32((void *)GPIO0_OR) & CFG_EEPROM_WP)); break; } } @@ -235,19 +225,6 @@ U_BOOT_CMD(eepwren, 2, 0, do_eep_wren, /* ------------------------------------------------------------------------- */ -#if defined(CONFIG_CMD_NAND) -#include <linux/mtd/nand_legacy.h> -extern struct nand_chip nand_dev_desc[CFG_MAX_NAND_DEVICE]; - -void nand_init(void) -{ - nand_probe(CFG_NAND_BASE); - if (nand_dev_desc[0].ChipID != NAND_ChipID_UNKNOWN) { - print_size(nand_dev_desc[0].totlen, "\n"); - } -} -#endif - void reset_phy(void) { #ifdef CONFIG_LXT971_NO_SLEEP |