diff options
Diffstat (limited to 'board/gdsys/gdppc440etx/gdppc440etx.c')
| -rw-r--r-- | board/gdsys/gdppc440etx/gdppc440etx.c | 161 |
1 files changed, 0 insertions, 161 deletions
diff --git a/board/gdsys/gdppc440etx/gdppc440etx.c b/board/gdsys/gdppc440etx/gdppc440etx.c deleted file mode 100644 index 04191dff1e..0000000000 --- a/board/gdsys/gdppc440etx/gdppc440etx.c +++ /dev/null @@ -1,161 +0,0 @@ -/* - * (C) Copyright 2008 - * Dirk Eibach, Guntermann & Drunck GmbH, eibach@gdsys.de - * - * Based on board/amcc/yosemite/yosemite.c - * (C) Copyright 2006-2007 - * Stefan Roese, DENX Software Engineering, sr@denx.de. - * - * SPDX-License-Identifier: GPL-2.0+ - */ - -#include <common.h> -#include <asm/ppc4xx.h> -#include <asm/processor.h> -#include <asm/io.h> -#include <asm/4xx_pci.h> - -DECLARE_GLOBAL_DATA_PTR; - -/* info for FLASH chips */ -extern flash_info_t flash_info[CONFIG_SYS_MAX_FLASH_BANKS]; - -int board_early_init_f(void) -{ - register uint reg; - - /* - * Setup the external bus controller/chip selects - */ - mfebc(EBC0_CFG, reg); - mtebc(EBC0_CFG, reg | 0x04000000); /* Set ATC */ - - /* - * Setup the GPIO pins - */ - - /* setup Address lines for flash size 64Meg. */ - out32(GPIO0_OSRL, in32(GPIO0_OSRL) | 0x54000000); - out32(GPIO0_TSRL, in32(GPIO0_TSRL) | 0x54000000); - out32(GPIO0_ISR1L, in32(GPIO0_ISR1L) | 0x54000000); - - /* setup emac */ - out32(GPIO0_TCR, in32(GPIO0_TCR) | 0xC080); - out32(GPIO0_TSRL, in32(GPIO0_TSRL) | 0x40); - out32(GPIO0_ISR1L, in32(GPIO0_ISR1L) | 0x55); - out32(GPIO0_OSRH, in32(GPIO0_OSRH) | 0x50004000); - out32(GPIO0_ISR1H, in32(GPIO0_ISR1H) | 0x00440000); - - /* UART0 and UART1*/ - out32(GPIO1_TCR, in32(GPIO1_TCR) | 0x16000000); - out32(GPIO1_OSRL, in32(GPIO1_OSRL) | 0x02180000); - out32(GPIO1_ISR1L, in32(GPIO1_ISR1L) | 0x00400000); - out32(GPIO1_ISR2L, in32(GPIO1_ISR2L) | 0x04010000); - - /* disable boot-eeprom WP */ - out32(GPIO0_OSRL, in32(GPIO0_OSRL) & ~0x00C00000); - out32(GPIO0_TSRL, in32(GPIO0_TSRL) & ~0x00C00000); - out32(GPIO0_ISR1L, in32(GPIO0_ISR1L) & ~0x00C00000); - out32(GPIO0_TCR, in32(GPIO0_TCR) | 0x08000000); - out32(GPIO0_OR, in32(GPIO0_OR) & ~0x08000000); - - /* external interrupts IRQ0...3 */ - out32(GPIO1_TCR, in32(GPIO1_TCR) & ~0x00f00000); - out32(GPIO1_TSRL, in32(GPIO1_TSRL) & ~0x00005500); - out32(GPIO1_ISR1L, in32(GPIO1_ISR1L) | 0x00005500); - - - /* - * Setup the interrupt controller polarities, triggers, etc. - */ - mtdcr(UIC0SR, 0xffffffff); /* clear all */ - mtdcr(UIC0ER, 0x00000000); /* disable all */ - mtdcr(UIC0CR, 0x00000009); /* ATI & UIC1 crit are critical */ - mtdcr(UIC0PR, 0xfffffe13); /* per ref-board manual */ - mtdcr(UIC0TR, 0x01c00008); /* per ref-board manual */ - mtdcr(UIC0VR, 0x00000001); /* int31 highest, base=0x000 */ - mtdcr(UIC0SR, 0xffffffff); /* clear all */ - - mtdcr(UIC1SR, 0xffffffff); /* clear all */ - mtdcr(UIC1ER, 0x00000000); /* disable all */ - mtdcr(UIC1CR, 0x00000000); /* all non-critical */ - mtdcr(UIC1PR, 0xffffe0ff); /* per ref-board manual */ - mtdcr(UIC1TR, 0x00ffc000); /* per ref-board manual */ - mtdcr(UIC1VR, 0x00000001); /* int31 highest, base=0x000 */ - mtdcr(UIC1SR, 0xffffffff); /* clear all */ - - /* - * Setup other serial configuration - */ - mfsdr(SDR0_PCI0, reg); - mtsdr(SDR0_PCI0, 0x80000000 | reg); /* PCI arbiter enabled */ - mtsdr(SDR0_PFC0, 0x00003e00); /* Pin function */ - mtsdr(SDR0_PFC1, 0x00048000); /* Pin function: UART0 has 4 pins */ - - return 0; -} - -int misc_init_r(void) -{ - uint pbcr; - int size_val; - uint sz; - - /* Re-do sizing to get full correct info */ - mfebc(PB0CR, pbcr); - - if (gd->bd->bi_flashsize > 0x08000000) - panic("Max. flash banksize is 128 MB!\n"); - - for (sz = gd->bd->bi_flashsize, size_val = 7; - ((sz & 0x08000000) == 0) && (size_val > 0); --size_val) - sz <<= 1; - - pbcr = (pbcr & 0x0001ffff) | gd->bd->bi_flashstart | (size_val << 17); - mtebc(PB0CR, pbcr); - - /* adjust flash start and offset */ - gd->bd->bi_flashstart = 0 - gd->bd->bi_flashsize; - gd->bd->bi_flashoffset = 0; - - /* Monitor protection ON by default */ - (void)flash_protect(FLAG_PROTECT_SET, - -CONFIG_SYS_MONITOR_LEN, - 0xffffffff, - &flash_info[0]); - - return 0; -} - -int checkboard(void) -{ - char buf[64]; - int i = getenv_f("serial#", buf, sizeof(buf)); - - printf("Board: GDPPC440ETX - G&D PPC440EP/GR ETX-module"); - - if (i > 0) { - puts(", serial# "); - puts(buf); - } - putc('\n'); - - return 0; -} - -/* - * Override weak pci_pre_init() - */ -#if defined(CONFIG_PCI) -int pci_pre_init(struct pci_controller *hose) -{ - /* First call common code */ - __pci_pre_init(hose); - - /* enable 66 MHz ext. Clock */ - out32(GPIO1_TCR, in32(GPIO1_TCR) | 0x00008000); - out32(GPIO1_OR, in32(GPIO1_OR) | 0x00008000); - - return 1; -} -#endif /* defined(CONFIG_PCI) */ |