diff options
Diffstat (limited to 'board/keymile/kmp204x/kmp204x.c')
| -rw-r--r-- | board/keymile/kmp204x/kmp204x.c | 48 |
1 files changed, 2 insertions, 46 deletions
diff --git a/board/keymile/kmp204x/kmp204x.c b/board/keymile/kmp204x/kmp204x.c index c93fa3c62e..0a6cf1fd29 100644 --- a/board/keymile/kmp204x/kmp204x.c +++ b/board/keymile/kmp204x/kmp204x.c @@ -24,6 +24,7 @@ #include <fm_eth.h> #include "../common/common.h" +#include "../common/qrio.h" #include "kmp204x.h" static uchar ivm_content[CONFIG_SYS_IVM_EEPROM_MAX_LEN]; @@ -35,51 +36,6 @@ int checkboard(void) return 0; } -/* I2C deblocking uses the algorithm defined in board/keymile/common/common.c - * 2 dedicated QRIO GPIOs externally pull the SCL and SDA lines - * For I2C only the low state is activly driven and high state is pulled-up - * by a resistor. Therefore the deblock GPIOs are used - * -> as an active output to drive a low state - * -> as an open-drain input to have a pulled-up high state - */ - -/* QRIO GPIOs used for deblocking */ -#define DEBLOCK_PORT1 GPIO_A -#define DEBLOCK_SCL1 20 -#define DEBLOCK_SDA1 21 - -/* By default deblock GPIOs are floating */ -static void i2c_deblock_gpio_cfg(void) -{ - /* set I2C bus 1 deblocking GPIOs input, but 0 value for open drain */ - qrio_gpio_direction_input(DEBLOCK_PORT1, DEBLOCK_SCL1); - qrio_gpio_direction_input(DEBLOCK_PORT1, DEBLOCK_SDA1); - - qrio_set_gpio(DEBLOCK_PORT1, DEBLOCK_SCL1, 0); - qrio_set_gpio(DEBLOCK_PORT1, DEBLOCK_SDA1, 0); -} - -void set_sda(int state) -{ - qrio_set_opendrain_gpio(DEBLOCK_PORT1, DEBLOCK_SDA1, state); -} - -void set_scl(int state) -{ - qrio_set_opendrain_gpio(DEBLOCK_PORT1, DEBLOCK_SCL1, state); -} - -int get_sda(void) -{ - return qrio_get_gpio(DEBLOCK_PORT1, DEBLOCK_SDA1); -} - -int get_scl(void) -{ - return qrio_get_gpio(DEBLOCK_PORT1, DEBLOCK_SCL1); -} - - #define ZL30158_RST 8 #define BFTIC4_RST 0 #define RSTRQSR1_WDT_RR 0x00200000 @@ -297,7 +253,7 @@ int ft_board_setup(void *blob, bd_t *bd) #if defined(CONFIG_POST) /* DIC26_SELFTEST GPIO used to start factory test sw */ -#define SELFTEST_PORT GPIO_A +#define SELFTEST_PORT QRIO_GPIO_A #define SELFTEST_PIN 31 int post_hotkeys_pressed(void) |