diff options
Diffstat (limited to 'board/ronetix/pm9g45/pm9g45.c')
| -rw-r--r-- | board/ronetix/pm9g45/pm9g45.c | 32 |
1 files changed, 15 insertions, 17 deletions
diff --git a/board/ronetix/pm9g45/pm9g45.c b/board/ronetix/pm9g45/pm9g45.c index fa69599e90..f3374a4429 100644 --- a/board/ronetix/pm9g45/pm9g45.c +++ b/board/ronetix/pm9g45/pm9g45.c @@ -29,16 +29,14 @@ #include <common.h> #include <asm/sizes.h> -#include <asm/arch/at91sam9g45.h> +#include <asm/io.h> #include <asm/arch/at91sam9_smc.h> #include <asm/arch/at91_common.h> #include <asm/arch/at91_pmc.h> #include <asm/arch/at91_rstc.h> #include <asm/arch/at91_matrix.h> -#include <asm/arch/at91_pio.h> +#include <asm/arch/gpio.h> #include <asm/arch/clk.h> -#include <asm/arch/io.h> -#include <asm/arch/hardware.h> #if defined(CONFIG_RESET_PHY_R) && defined(CONFIG_MACB) #include <net.h> #endif @@ -54,9 +52,9 @@ DECLARE_GLOBAL_DATA_PTR; static void pm9g45_nand_hw_init(void) { unsigned long csa; - at91_smc_t *smc = (at91_smc_t *) AT91_SMC_BASE; - at91_matrix_t *matrix = (at91_matrix_t *) AT91_MATRIX_BASE; - at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE; + struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC; + struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX; + struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC; /* Enable CS3 */ csa = readl(&matrix->ccr[6]) | AT91_MATRIX_CSA_EBI_CS3A; @@ -80,7 +78,7 @@ static void pm9g45_nand_hw_init(void) AT91_SMC_MODE_TDF_CYCLE(3), &smc->cs[3].mode); - writel(1 << AT91SAM9G45_ID_PIOC, &pmc->pcer); + writel(1 << ATMEL_ID_PIOC, &pmc->pcer); #ifdef CONFIG_SYS_NAND_READY_PIN /* Configure RDY/BSY */ @@ -95,7 +93,7 @@ static void pm9g45_nand_hw_init(void) #ifdef CONFIG_MACB static void pm9g45_macb_hw_init(void) { - at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE; + struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC; /* * PD2 enables the 50MHz oscillator for Ethernet PHY @@ -106,7 +104,7 @@ static void pm9g45_macb_hw_init(void) at91_set_pio_value(AT91_PIO_PORTD, 2, 1); /* 1- enable, 0 - disable */ /* Enable clock */ - writel(1 << AT91SAM9G45_ID_EMAC, &pmc->pcer); + writel(1 << ATMEL_ID_EMAC, &pmc->pcer); /* * Disable pull-up on: @@ -131,22 +129,22 @@ static void pm9g45_macb_hw_init(void) int board_init(void) { - at91_pmc_t *pmc = (at91_pmc_t *) AT91_PMC_BASE; + struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC; /* Enable Ctrlc */ console_init_f(); - writel((1 << AT91SAM9G45_ID_PIOA) | - (1 << AT91SAM9G45_ID_PIOB) | - (1 << AT91SAM9G45_ID_PIOC) | - (1 << AT91SAM9G45_ID_PIODE), &pmc->pcer); + writel((1 << ATMEL_ID_PIOA) | + (1 << ATMEL_ID_PIOB) | + (1 << ATMEL_ID_PIOC) | + (1 << ATMEL_ID_PIODE), &pmc->pcer); /* arch number of AT91SAM9M10G45EK-Board */ gd->bd->bi_arch_number = MACH_TYPE_PM9G45; /* adress of boot parameters */ gd->bd->bi_boot_params = PHYS_SDRAM + 0x100; - at91_serial_hw_init(); + at91_seriald_hw_init(); #ifdef CONFIG_CMD_NAND pm9g45_nand_hw_init(); #endif @@ -188,7 +186,7 @@ int board_eth_init(bd_t *bis) { int rc = 0; #ifdef CONFIG_MACB - rc = macb_eth_initialize(0, (void *)AT91_EMAC_BASE, 0x01); + rc = macb_eth_initialize(0, (void *)ATMEL_BASE_EMAC, 0x01); #endif return rc; } |