1 files changed, 0 insertions, 30 deletions
diff --git a/board/rpxsuper/readme b/board/rpxsuper/readme
deleted file mode 100644
index 21267bdd8c..0000000000
--- a/board/rpxsuper/readme
+++ /dev/null
@@ -1,30 +0,0 @@
-Hi,
-
-so this is the port to the Embedded Planet RPX Super Board.
-
-ATTENTION
-This code is only tested on the AY-Version, which is an early release with some
-hardware bugs. The main problem is that this board uses the default Hard Reset
-Configuration Word and not the 4 bytes located at start of FLASH because at
-0xFE000000 is no FLASH. The FLASH consists out of 4 chips each 16bits wide. Be
-carefull, the bytes are swapped. So DQ0-7 is the high byte, DQ8-15 ist the low
-byte.
-
-The icache can only manually be enabled after reset.
-The FLASH and main SDRAM is working with icache enabled.
-The local SDRAM can only be used as data memory when icache is enabled.
-If U-Boot runs in local SDRAM, TFTP does not work.
-The functions in mii_phy.c are all working. Call mii_phy_discover() out of
-eth_init() and solve the linker error.
-I2C, RTC/NVRAM and PCMCIA are not working yet.
-
-TODO
-The 32MB local SDRAM is working but not shown in the startup messages of
-U-Boot. If you locate U-Boot or any other program to this area it won't run.
-Turning the ichache off does not solve this problem.
-
-As I won't buy another RPX Super there might be some little work to do for you
-getting this U-Boot port running on the final board.
-
-
-frank.morauf@salzbrenner.com