3 files changed, 43 insertions, 17 deletions

diff --git a/board/siemens/draco/board.c b/board/siemens/draco/board.c
index ede73baf3e..2697762076 100644
--- a/board/siemens/draco/board.c
+++ b/board/siemens/draco/board.c
@@ -43,7 +43,7 @@ static struct draco_baseboard_id __attribute__((section(".data"))) settings;
 /* Default@303MHz-i0 */
 const struct ddr3_data ddr3_default = {
 	0x33524444, 0x56312e35, 0x0080, 0x0000, 0x003A, 0x003F, 0x009F,
-	0x0079, 0x0888A39B, 0x26247FDA, 0x501F821F, 0x00100206, 0x61A44A32,
+	0x0079, 0x0888A39B, 0x26517FDA, 0x501F84EF, 0x00100206, 0x61A44A32,
 	0x0000093B, 0x0000014A,
 	"default name @303MHz           \0",
 	"default marking                \0",
@@ -71,8 +71,8 @@ static void print_ddr3_timings(void)
 	printf("clock:\t\t%d MHz\n", DDR_PLL_FREQ);
 	printf("device:\t\t%s\n", settings.ddr3.manu_name);
 	printf("marking:\t%s\n", settings.ddr3.manu_marking);
-	printf("timing parameters\n");
-	printf("diff\teeprom\tdefault\n");
+	printf("%-20s, %-8s, %-8s, %-4s\n", "timing parameters", "eeprom",
+	       "default", "diff");
 	PRINTARGS(magic);
 	PRINTARGS(version);
 	PRINTARGS(ddr3_sratio);
@@ -96,9 +96,12 @@ static void print_ddr3_timings(void)
 
 static void print_chip_data(void)
 {
+	struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
+	dpll_mpu_opp100.m = am335x_get_efuse_mpu_max_freq(cdev);
 	printf("\nCPU BOARD\n");
 	printf("device: \t'%s'\n", settings.chip.sdevname);
 	printf("hw version: \t'%s'\n", settings.chip.shwver);
+	printf("max freq: \t%d MHz\n", dpll_mpu_opp100.m);
 }
 #endif /* CONFIG_SPL_BUILD */
 
@@ -193,6 +196,11 @@ struct ctrl_ioregs draco_ddr3_ioregs = {
 
 	config_ddr(DDR_PLL_FREQ, &draco_ddr3_ioregs, &draco_ddr3_data,
 		   &draco_ddr3_cmd_ctrl_data, &draco_ddr3_emif_reg_data, 0);
+
+	/* For Samsung 2Gbit RAM we need this delay otherwise config fails after
+	 * soft reset.
+	 */
+	udelay(2000);
 }
 
 static void spl_siemens_board_init(void)
@@ -201,6 +209,26 @@ static void spl_siemens_board_init(void)
 }
 #endif /* if def CONFIG_SPL_BUILD */
 
+#ifdef CONFIG_BOARD_LATE_INIT
+int board_late_init(void)
+{
+	omap_nand_switch_ecc(1, 8);
+#ifdef CONFIG_FACTORYSET
+	/* Set ASN in environment*/
+	if (factory_dat.asn[0] != 0) {
+		setenv("dtb_name", (char *)factory_dat.asn);
+	} else {
+		/* dtb suffix gets added in load script */
+		setenv("dtb_name", "am335x-draco");
+	}
+#else
+	setenv("dtb_name", "am335x-draco");
+#endif
+
+	return 0;
+}
+#endif
+
 #if (defined(CONFIG_DRIVER_TI_CPSW) && !defined(CONFIG_SPL_BUILD)) || \
 	(defined(CONFIG_SPL_ETH_SUPPORT) && defined(CONFIG_SPL_BUILD))
 static void cpsw_control(int enabled)
@@ -280,13 +308,4 @@ U_BOOT_CMD(
 #endif /* #if defined(CONFIG_DRIVER_TI_CPSW) */
 #endif /* #if (defined(CONFIG_DRIVER_TI_CPSW) && !defined(CONFIG_SPL_BUILD)) */
 
-#ifdef CONFIG_BOARD_LATE_INIT
-int board_late_init(void)
-{
-	omap_nand_switch_ecc(1, 8);
-
-	return 0;
-}
-#endif
-
 #include "../common/board.c"
diff --git a/board/siemens/draco/board.h b/board/siemens/draco/board.h
index ff8ab764c5..8856fd0f86 100644
--- a/board/siemens/draco/board.h
+++ b/board/siemens/draco/board.h
@@ -16,9 +16,13 @@
 #ifndef _BOARD_H_
 #define _BOARD_H_
 
-#define PARGS3(x)	settings.ddr3.x-ddr3_default.x, \
-			settings.ddr3.x, ddr3_default.x
-#define PRINTARGS(y)	printf("%x, %8x, %8x : "#y"\n", PARGS3(y))
+#define PARGS(x)	#x , /* Parameter Name */ \
+			settings.ddr3.x, /* EEPROM Value */ \
+			ddr3_default.x, /* Default Value */ \
+			settings.ddr3.x-ddr3_default.x /* Difference */
+
+#define PRINTARGS(y)	printf("%-20s, %8x, %8x, %4d\n", PARGS(y))
+
 #define MAGIC_CHIP	0x50494843
 
 /* Automatic generated definition */
@@ -69,4 +73,7 @@ void enable_uart4_pin_mux(void);
 void enable_uart5_pin_mux(void);
 void enable_i2c0_pin_mux(void);
 void enable_board_pin_mux(void);
+
+/* Forwared declaration, defined in common board.c */
+void set_env_gpios(unsigned char state);
 #endif
diff --git a/board/siemens/draco/mux.c b/board/siemens/draco/mux.c
index eaa3c70798..dbcc80b61f 100644
--- a/board/siemens/draco/mux.c
+++ b/board/siemens/draco/mux.c
@@ -60,7 +60,7 @@ static struct module_pin_mux nand_pin_mux[] = {
 
 static struct module_pin_mux gpios_pin_mux[] = {
 	/* DFU button GPIO0_27*/
-	{OFFSET(gpmc_ad11), (MODE(7) | PULLUDEN | RXACTIVE)},
+	{OFFSET(gpmc_ad11), (MODE(7) | PULLUDEN | PULLUP_EN | RXACTIVE)},
 	{OFFSET(gpmc_csn3), MODE(7) },			/* LED0 GPIO2_0 */
 	{OFFSET(emu0), MODE(7)},			/* LED1 GPIO3_7 */
 	/* Triacs in HW Rev 2 */
@@ -222,7 +222,7 @@ static struct module_pin_mux gpios_pin_mux[] = {
 	{OFFSET(vrefp), MODE(7) | RXACTIVE | PULLUDDIS},
 	{OFFSET(vrefn), MODE(7) | RXACTIVE | PULLUDDIS},
 	/* nRST for SMSC LAN9303 switch - GPIO2_24 */
-	{OFFSET(lcd_pclk), MODE(7) },			/* LAN9303 nRST */
+	{OFFSET(lcd_pclk), MODE(7) | PULLUDEN | PULLUP_EN }, /* LAN9303 nRST */
 	{-1},
 };