diff options
Diffstat (limited to 'board')
| -rw-r--r-- | board/freescale/common/sys_eeprom.c | 18 |
1 files changed, 17 insertions, 1 deletions
diff --git a/board/freescale/common/sys_eeprom.c b/board/freescale/common/sys_eeprom.c index 3929ad0aac..43f61f9541 100644 --- a/board/freescale/common/sys_eeprom.c +++ b/board/freescale/common/sys_eeprom.c @@ -204,7 +204,7 @@ static void update_crc(void) */ static int prog_eeprom(void) { - int ret = 0; /* shut up gcc */ + int ret = 0; int i; void *p; #ifdef CONFIG_SYS_EEPROM_BUS_NUM @@ -225,6 +225,11 @@ static int prog_eeprom(void) i2c_set_bus_num(CONFIG_SYS_EEPROM_BUS_NUM); #endif + /* + * The AT24C02 datasheet says that data can only be written in page + * mode, which means 8 bytes at a time, and it takes up to 5ms to + * complete a given write. + */ for (i = 0, p = &e; i < sizeof(e); i += 8, p += 8) { ret = i2c_write(CONFIG_SYS_I2C_EEPROM_ADDR, i, CONFIG_SYS_I2C_EEPROM_ADDR_LEN, p, min((sizeof(e) - i), 8)); @@ -233,12 +238,23 @@ static int prog_eeprom(void) udelay(5000); /* 5ms write cycle timing */ } + if (!ret) { + /* Verify the write by reading back the EEPROM and comparing */ + struct eeprom e2; + + ret = i2c_read(CONFIG_SYS_I2C_EEPROM_ADDR, 0, + CONFIG_SYS_I2C_EEPROM_ADDR_LEN, (void *)&e2, sizeof(e2)); + if (!ret && memcmp(&e, &e2, sizeof(e))) + ret = -1; + } + #ifdef CONFIG_SYS_EEPROM_BUS_NUM i2c_set_bus_num(bus); #endif if (ret) { printf("Programming failed.\n"); + has_been_read = 0; return -1; } |