diff options
Diffstat (limited to 'include/configs/NC650.h')
| -rw-r--r-- | include/configs/NC650.h | 66 |
1 files changed, 48 insertions, 18 deletions
diff --git a/include/configs/NC650.h b/include/configs/NC650.h index 3c59df4f45..8da29c4afc 100644 --- a/include/configs/NC650.h +++ b/include/configs/NC650.h @@ -1,4 +1,5 @@ /* + * (C) Copyright 2006 Detlev Zundel, dzu@denx.de * (C) Copyright 2005 * Wolfgang Denk, DENX Software Engineering, wd@denx.de. * @@ -65,6 +66,11 @@ #define CFG_8XX_XIN CONFIG_8xx_OSCLK #define CONFIG_BOOTDELAY 5 /* autoboot after 5 seconds */ +#define CONFIG_AUTOBOOT_KEYED +#define CONFIG_AUTOBOOT_PROMPT "\nEnter password - autoboot in %d seconds...\n" +#define CONFIG_AUTOBOOT_DELAY_STR "ids" +#define CONFIG_BOOT_RETRY_TIME 900 +#define CONFIG_BOOT_RETRY_MIN 30 #define CONFIG_PREBOOT "echo;echo Type \"run flash_nfs\" to mount root filesystem over NFS;echo" @@ -75,7 +81,7 @@ "ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}:${hostname}::off;" \ "bootm" -#undef CONFIG_WATCHDOG /* watchdog disabled */ +#define CONFIG_WATCHDOG /* watchdog enabled */ #undef CONFIG_STATUS_LED /* Status LED disabled */ @@ -96,12 +102,26 @@ /* * Software (bit-bang) I2C driver configuration */ +#if defined(CONFIG_IDS852_REV1) + #define SCL 0x1000 /* PA 3 */ #define SDA 0x2000 /* PA 2 */ #define __I2C_DIR immr->im_ioport.iop_padir #define __I2C_DAT immr->im_ioport.iop_padat #define __I2C_PAR immr->im_ioport.iop_papar + +#elif defined(CONFIG_IDS852_REV2) + +#define SCL 0x0002 /* PB 30 */ +#define SDA 0x0001 /* PB 31 */ + +#define __I2C_PAR immr->im_cpm.cp_pbpar +#define __I2C_DIR immr->im_cpm.cp_pbdir +#define __I2C_DAT immr->im_cpm.cp_pbdat + +#endif + #define I2C_INIT { __I2C_PAR &= ~(SDA|SCL); \ __I2C_DIR |= (SDA|SCL); } #define I2C_READ ((__I2C_DAT & SDA) ? 1 : 0) @@ -229,17 +249,6 @@ #define ADDR_COLUMN 1 #define NAND_NO_RB -#define NAND_WAIT_READY(nand) udelay(12) -#define WRITE_NAND_COMMAND(d, adr) WRITE_NAND(d, adr + 2) -#define WRITE_NAND_ADDRESS(d, adr) WRITE_NAND(d, adr + 1) -#define WRITE_NAND(d, adr) (*(volatile uint8_t *)(adr) = (uint8_t)(d)) -#define READ_NAND(adr) (*(volatile uint8_t *)(adr)) -#define NAND_DISABLE_CE(nand) /* nop */ -#define NAND_ENABLE_CE(nand) /* nop */ -#define NAND_CTL_CLRALE(nandptr) /* nop */ -#define NAND_CTL_SETALE(nandptr) /* nop */ -#define NAND_CTL_CLRCLE(nandptr) /* nop */ -#define NAND_CTL_SETCLE(nandptr) /* nop */ /*----------------------------------------------------------------------- * SYPCR - System Protection Control 11-9 @@ -312,7 +321,8 @@ #define CFG_BR0_PRELIM ((FLASH_BASE0_PRELIM & BR_BA_MSK) | BR_PS_8 | BR_V) /* - * BR2 and OR2 (NAND Flash) - now addressed through UPMB + * BR2 and OR2 (NAND Flash) - addressed through UPMB on rev 1 + * rev2 only uses the chipselect */ #define CFG_NAND_BASE 0x50000000 #define CFG_NAND_SIZE 0x04000000 @@ -338,6 +348,18 @@ #define CFG_BR3_PRELIM ((SDRAM_BASE3_PRELIM & BR_BA_MSK) | BR_MS_UPMA | BR_V) /* + * BR4 and OR4 (CPLD) + */ +#define CFG_CPLD_BASE 0x80000000 /* CPLD */ +#define CFG_CPLD_SIZE 0x10000 /* only 16 used */ + +#define CFG_OR_TIMING_CPLD (OR_CSNT_SAM | OR_ACS_DIV1 | OR_BI | \ + OR_SCY_1_CLK) + +#define CFG_BR4_PRELIM ((CFG_CPLD_BASE & BR_BA_MSK) | BR_PS_8 | BR_V ) +#define CFG_OR4_PRELIM (((-CFG_CPLD_SIZE) & OR_AM_MSK) | CFG_OR_TIMING_CPLD) + +/* * BR5 and OR5 (SRAM) */ #define CFG_SRAM_BASE 0x60000000 @@ -349,6 +371,16 @@ #define CFG_BR5_PRELIM ((CFG_SRAM_BASE & BR_BA_MSK) | BR_PS_8 | BR_V ) #define CFG_OR5_PRELIM (((-CFG_SRAM_SIZE) & OR_AM_MSK) | CFG_OR_TIMING_SRAM) +#if defined(CONFIG_CP850) +/* + * BR6 and OR6 (DPRAM) - only on CP850 + */ +#define CFG_OR6_PRELIM 0xffff8170 +#define CFG_BR6_PRELIM 0xa0000401 +#define DPRAM_BASE_ADDR 0xa0000000 + +#define CONFIG_MISC_INIT_R 1 +#endif /* * 4096 Rows from SDRAM example configuration @@ -413,14 +445,12 @@ #define CONFIG_JFFS2_PART_OFFSET 0x00000000 /* mtdparts command line support */ -/* #define CONFIG_JFFS2_CMDLINE #define MTDIDS_DEFAULT "nor0=nc650-0,nand0=nc650-nand" #define MTDPARTS_DEFAULT "mtdparts=nc650-0:1m(kernel1),1m(kernel2)," \ - "2560k(cramfs1),2560k(cramfs2)," \ - "256k(u-boot),256k(env);" \ - "nc650-nand:4m(nand1),28m(nand2)" -*/ + "4m(cramfs1),1m(cramfs2)," \ + "256k(u-boot),128k(env);" \ + "nc650-nand:4m(jffs1),28m(jffs2)" #endif /* __CONFIG_H */ |