diff options
Diffstat (limited to 'include/configs/PM856.h')
| -rw-r--r-- | include/configs/PM856.h | 58 |
1 files changed, 28 insertions, 30 deletions
diff --git a/include/configs/PM856.h b/include/configs/PM856.h index b2cf06000f..244f09aa95 100644 --- a/include/configs/PM856.h +++ b/include/configs/PM856.h @@ -45,11 +45,6 @@ #define CONFIG_PCI #define CONFIG_TSEC_ENET /* tsec ethernet support */ #define CONFIG_ENV_OVERWRITE -#undef CONFIG_SPD_EEPROM /* do not use SPD EEPROM for DDR setup*/ -#define CONFIG_DDR_ECC /* only for ECC DDR module */ -#define CONFIG_DDR_DLL /* possible DLL fix needed */ -#define CONFIG_DDR_2T_TIMING /* Sets the 2T timing bit */ -#define CONFIG_MEM_INIT_VALUE 0xDEADBEEF #define CONFIG_FSL_LAW 1 /* Use common FSL init code */ @@ -97,33 +92,36 @@ #define CFG_CCSRBAR_PHYS CFG_CCSRBAR /* physical addr of CCSRBAR */ #define CFG_IMMR CFG_CCSRBAR /* PQII uses CFG_IMMR */ +/* DDR Setup */ +#define CONFIG_FSL_DDR1 +#undef CONFIG_FSL_DDR_INTERACTIVE +#undef CONFIG_SPD_EEPROM /* Use SPD EEPROM for DDR setup */ +#undef CONFIG_DDR_SPD +#define CONFIG_DDR_DLL /* possible DLL fix needed */ +#define CONFIG_DDR_ECC /* only for ECC DDR module */ -/* - * DDR Setup - */ -#define CFG_DDR_SDRAM_BASE 0x00000000 /* DDR is system memory*/ -#define CFG_SDRAM_BASE CFG_DDR_SDRAM_BASE - -#if defined(CONFIG_SPD_EEPROM) - /* - * Determine DDR configuration from I2C interface. - */ - #define SPD_EEPROM_ADDRESS 0x58 /* DDR DIMM */ - -#else - /* - * Manually set up DDR parameters - */ - #define CFG_SDRAM_SIZE 256 /* DDR is 256 MB */ - #define CFG_DDR_CS0_BNDS 0x0000000f /* 0-256MB */ - #define CFG_DDR_CS0_CONFIG 0x80000102 - #define CFG_DDR_TIMING_1 0x47444321 - #define CFG_DDR_TIMING_2 0x00000800 /* P9-45,may need tuning */ - #define CFG_DDR_CONTROL 0xc2008000 /* unbuffered,no DYN_PWR */ - #define CFG_DDR_MODE 0x00000062 /* DLL,normal,seq,4/2.5 */ - #define CFG_DDR_INTERVAL 0x045b0100 /* autocharge,no open page */ -#endif +#define CONFIG_MEM_INIT_VALUE 0xDeadBeef +#define CFG_DDR_SDRAM_BASE 0x00000000 +#define CFG_SDRAM_BASE CFG_DDR_SDRAM_BASE +#define CONFIG_VERY_BIG_RAM + +#define CONFIG_NUM_DDR_CONTROLLERS 1 +#define CONFIG_DIMM_SLOTS_PER_CTLR 1 +#define CONFIG_CHIP_SELECTS_PER_CTRL 2 + +/* I2C addresses of SPD EEPROMs */ +#define SPD_EEPROM_ADDRESS 0x58 /* CTLR 0 DIMM 0 */ + +/* Manually set up DDR parameters */ +#define CFG_SDRAM_SIZE 256 /* DDR is 256 MB */ +#define CFG_DDR_CS0_BNDS 0x0000000f /* 0-256MB */ +#define CFG_DDR_CS0_CONFIG 0x80000102 +#define CFG_DDR_TIMING_1 0x47444321 +#define CFG_DDR_TIMING_2 0x00000800 /* P9-45,may need tuning */ +#define CFG_DDR_CONTROL 0xc2008000 /* unbuffered,no DYN_PWR */ +#define CFG_DDR_MODE 0x00000062 /* DLL,normal,seq,4/2.5 */ +#define CFG_DDR_INTERVAL 0x045b0100 /* autocharge,no open page */ /* * SDRAM on the Local Bus |