diff options
Diffstat (limited to 'include/configs/ap_sh4a_4a.h')
| -rw-r--r-- | include/configs/ap_sh4a_4a.h | 102 |
1 files changed, 0 insertions, 102 deletions
diff --git a/include/configs/ap_sh4a_4a.h b/include/configs/ap_sh4a_4a.h deleted file mode 100644 index edcc0cbc8a..0000000000 --- a/include/configs/ap_sh4a_4a.h +++ /dev/null @@ -1,102 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0+ */ -/* - * Configuation settings for the Alpha Project AP-SH4A-4A board - * - * Copyright (C) 2012 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com> - */ - -#ifndef __AP_SH4A_4A_H -#define __AP_SH4A_4A_H - -#define CONFIG_CPU_SH7734 1 -#define CONFIG_400MHZ_MODE 1 - -#define CONFIG_DISPLAY_BOARDINFO -#undef CONFIG_SHOW_BOOT_PROGRESS - -/* Ether */ -#define CONFIG_SH_ETHER_USE_PORT (0) -#define CONFIG_SH_ETHER_PHY_ADDR (0x0) -#define CONFIG_SH_ETHER_PHY_MODE (PHY_INTERFACE_MODE_GMII) -#define CONFIG_SH_ETHER_SH7734_MII (0x02) /* GMII */ -#define CONFIG_BITBANGMII -#define CONFIG_BITBANGMII_MULTI - -/* undef to save memory */ -/* Monitor Command Prompt */ -/* Buffer size for Console output */ -#define CONFIG_SYS_PBSIZE 256 -/* List of legal baudrate settings for this board */ -#define CONFIG_SYS_BAUDRATE_TABLE { 115200 } - -/* SCIF */ -#define CONFIG_SCIF 1 -#define CONFIG_CONS_SCIF4 1 - -/* Suppress display of console information at boot */ - -/* SDRAM */ -#define CONFIG_SYS_SDRAM_BASE (0x88000000) -#define CONFIG_SYS_SDRAM_SIZE (64 * 1024 * 1024) -#define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024) - -#define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE) -#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + CONFIG_SYS_SDRAM_SIZE) -/* Enable alternate, more extensive, memory test */ -/* Scratch address used by the alternate memory test */ -#undef CONFIG_SYS_MEMTEST_SCRATCH - -/* Enable temporary baudrate change while serial download */ -#undef CONFIG_SYS_LOADS_BAUD_CHANGE - -/* FLASH */ -#undef CONFIG_SYS_FLASH_QUIET_TEST -#define CONFIG_SYS_FLASH_EMPTY_INFO -#define CONFIG_SYS_FLASH_BASE (0xA0000000) -#define CONFIG_SYS_MAX_FLASH_SECT 512 - -/* if you use all NOR Flash , you change dip-switch. Please see Manual. */ -#define CONFIG_SYS_MAX_FLASH_BANKS 1 -#define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE } - -/* Timeout for Flash erase operations (in ms) */ -#define CONFIG_SYS_FLASH_ERASE_TOUT (3 * 1000) -/* Timeout for Flash write operations (in ms) */ -#define CONFIG_SYS_FLASH_WRITE_TOUT (3 * 1000) -/* Timeout for Flash set sector lock bit operations (in ms) */ -#define CONFIG_SYS_FLASH_LOCK_TOUT (3 * 1000) -/* Timeout for Flash clear lock bit operations (in ms) */ -#define CONFIG_SYS_FLASH_UNLOCK_TOUT (3 * 1000) - -/* - * Use hardware flash sectors protection instead - * of U-Boot software protection - */ -#undef CONFIG_SYS_DIRECT_FLASH_TFTP - -/* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */ -#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_FLASH_BASE) -/* Monitor size */ -#define CONFIG_SYS_MONITOR_LEN (256 * 1024) -/* Size of DRAM reserved for malloc() use */ -#define CONFIG_SYS_MALLOC_LEN (256 * 1024) -#define CONFIG_SYS_BOOTMAPSZ (8 * 1024 * 1024) - -/* ENV setting */ -#define CONFIG_ENV_OVERWRITE 1 -#define CONFIG_ENV_SECT_SIZE (128 * 1024) -#define CONFIG_ENV_SIZE (CONFIG_ENV_SECT_SIZE) -#define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN) -/* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */ -#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) -#define CONFIG_ENV_SIZE_REDUND (CONFIG_ENV_SECT_SIZE) - -/* Board Clock */ -#if defined(CONFIG_400MHZ_MODE) -#define CONFIG_SYS_CLK_FREQ 50000000 -#else -#define CONFIG_SYS_CLK_FREQ 44444444 -#endif -#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ - -#endif /* __AP_SH4A_4A_H */ |