diff options
Diffstat (limited to 'include/mmc.h')
| -rw-r--r-- | include/mmc.h | 30 |
1 files changed, 30 insertions, 0 deletions
diff --git a/include/mmc.h b/include/mmc.h index 8bbc6b6ebe..566db59ac9 100644 --- a/include/mmc.h +++ b/include/mmc.h @@ -68,6 +68,7 @@ #define UNUSABLE_ERR -17 /* Unusable Card */ #define COMM_ERR -18 /* Communications Error */ #define TIMEOUT -19 +#define IN_PROGRESS -20 /* operation is in progress */ #define MMC_CMD_GO_IDLE_STATE 0 #define MMC_CMD_SEND_OP_COND 1 @@ -270,6 +271,10 @@ struct mmc { int (*getcd)(struct mmc *mmc); int (*getwp)(struct mmc *mmc); uint b_max; + char op_cond_pending; /* 1 if we are waiting on an op_cond command */ + char init_in_progress; /* 1 if we have done mmc_start_init() */ + char preinit; /* start init as early as possible */ + uint op_cond_response; /* the response byte from the last op_cond */ }; int mmc_register(struct mmc *mmc); @@ -287,6 +292,31 @@ int mmc_getcd(struct mmc *mmc); int mmc_getwp(struct mmc *mmc); void spl_mmc_load(void) __noreturn; +/** + * Start device initialization and return immediately; it does not block on + * polling OCR (operation condition register) status. Then you should call + * mmc_init, which would block on polling OCR status and complete the device + * initializatin. + * + * @param mmc Pointer to a MMC device struct + * @return 0 on success, IN_PROGRESS on waiting for OCR status, <0 on error. + */ +int mmc_start_init(struct mmc *mmc); + +/** + * Set preinit flag of mmc device. + * + * This will cause the device to be pre-inited during mmc_initialize(), + * which may save boot time if the device is not accessed until later. + * Some eMMC devices take 200-300ms to init, but unfortunately they + * must be sent a series of commands to even get them to start preparing + * for operation. + * + * @param mmc Pointer to a MMC device struct + * @param preinit preinit flag value + */ +void mmc_set_preinit(struct mmc *mmc, int preinit); + #ifdef CONFIG_GENERIC_MMC #define mmc_host_is_spi(mmc) ((mmc)->host_caps & MMC_MODE_SPI) struct mmc *mmc_spi_init(uint bus, uint cs, uint speed, uint mode); |