Age | Commit message (Expand) | Author |
2015-02-10 | imx: mx6: Fixed AIPS3 base address issue | Ye.Li |
2014-11-21 | mx6: thermal: Check cpu temperature via thermal sensor | Ye.Li |
2014-11-12 | arm: imx: make bmode command work with SPL/U-Boot combo | Nikita Kiryanov |
2014-11-05 | Merge branch 'master' of git://www.denx.de/git/u-boot-imx | Tom Rini |
2014-11-03 | imx: mx6sl: Set the preclk clock source to OSC 24Mhz | Ye.Li |
2014-10-27 | Merge branch 'master' of git://git.denx.de/u-boot-imx | Tom Rini |
2014-10-25 | imx: add missing includes | Jeroen Hofstee |
2014-10-21 | ARM: i.MX6: include prototype for get_board_rev() | Eric Nelson |
2014-09-29 | imx: mx6: Checking PLL2 PFD0 and PFD2 for periph_clk before PFD reset | Ye.Li |
2014-09-22 | imx: Support i.MX6 High Assurance Boot authentication | Nitin Garg |
2014-09-09 | mx6: Fix ECSPI typo in soc_boot_modes | Nikolay Dimitrov |
2014-09-09 | iMX6: Disable the L2 before chaning the PL310 latency | Ye.Li |
2014-08-20 | mx6: add support of multi-processor command | Gabriel Huau |
2014-07-23 | mx6: soc: Do not apply the PFD erratum for mx6solox | Fabio Estevam |
2014-07-10 | mx6: Add support for the mx6solox variant | Fabio Estevam |
2014-07-09 | mx6: soc: Update the comments of set_ldo_voltage() | Fabio Estevam |
2014-02-11 | mx6: Enable L2 cache support | Fabio Estevam |
2014-02-11 | mx6: Distinguish mx6dual from mx6quad | Fabio Estevam |
2014-02-11 | imx6: make sure MMDC_CHx_MASK is clear to avoid warm reset failure | Anson Huang |
2014-02-11 | imx6: ensure AHB clock is 132MHz in low freq boot mode | Anson Huang |
2014-01-17 | mx6: Revert "mx6: soc: Disable VDDPU regulator" | Fabio Estevam |
2014-01-02 | mx6: soc: Disable VDDPU regulator | Fabio Estevam |
2014-01-02 | mx6: soc: Add the required LDO ramp up delay | Fabio Estevam |
2014-01-02 | mx6: soc: Introduce set_ldo_voltage() | Fabio Estevam |
2014-01-02 | mx6: soc: Set the VDDSOC at 1.175 V | Fabio Estevam |
2014-01-02 | mx6: soc: Clear the LDO ramp values up prior to setting the LDO voltages | Fabio Estevam |
2014-01-02 | mx6: soc: Staticize set_vddsoc() | Fabio Estevam |
2013-12-17 | imx6: fix random hang when download by usb | Frank Li |
2013-08-31 | i.MX6: Set and clear the gating bits for Phase Fractional Dividers | Eric Nelson |
2013-07-31 | Merge git://git.denx.de/u-boot-arm | Stefano Babic |
2013-07-27 | mx6: Factor out common HDMI setup code | Pardeep Kumar Singla |
2013-07-24 | Add GPL-2.0+ SPDX-License-Identifier to source files | Wolfgang Denk |
2013-04-28 | imx: Homogenize and fix fuse register definitions | Benoît Thébaudeau |
2013-04-22 | mtd: mxs_nand: Add support for i.MX6 | Stefan Roese |
2013-04-03 | mx6: Fix get_board_rev() for the mx6 solo case | Fabio Estevam |
2013-03-07 | ARM: mx6: use common CPU errata config options | Stephen Warren |
2013-02-12 | mx6: Disable Power Down Bit of watchdog | Fabio Estevam |
2012-11-10 | mx6: soc: update get_cpu_rev and get_imx_type for mx6solo/sololite | Troy Kisky |
2012-10-15 | i.MX6: get rid of redundant struct src_regs (dupe of struct src) | Eric Nelson |
2012-09-01 | imx-common/cmd_bmode.c: add imx bmode (bootmode) command | Troy Kisky |
2012-07-07 | No need to define CONFIG_ARCH_CPU_INIT. | Fabio Estevam |
2012-05-15 | i.MX6: Add ANATOP regulator init | Dirk Behme |
2012-04-16 | i.MX6: implement enable_caches() | Eric Nelson |
2012-03-27 | mx6: Read silicon revision from register | Fabio Estevam |
2012-01-16 | imx: mx6q: add aipstz init for off platform periph | Jason Liu |
2012-01-16 | i.mx6:imx6q: allign MAC address with burned-in ordering | Jason Liu |
2012-01-16 | net: imx: Add multi-FEC support for imx_get_mac_from_fuse | Fabio Estevam |
2011-12-09 | i.mx: add the initial support for freescale i.MX6Q processor | Jason Liu |