summaryrefslogtreecommitdiff
path: root/arch/arm/include/asm/arch-mx6
AgeCommit message (Expand)Author
2013-04-28Add mxc_ocotp driverBenoît Thébaudeau
2013-04-28imx: Add useful fuse definitionsBenoît Thébaudeau
2013-04-28imx: Homogenize and fix fuse register definitionsBenoît Thébaudeau
2013-04-25wandboard: Add support for Carrier Board MicroSD cardOtavio Salvador
2013-04-25wandboard: Add card detection for SOM MicroSD cardOtavio Salvador
2013-04-25nitrogen6x: Setup CCM_CCOSR registerFabio Estevam
2013-04-25arm: imx: Codingstyle enhancement of include/asm/arch-mx6/crm_regs.hStefan Roese
2013-04-22imx: Add titanium board support (i.MX6 based)Stefan Roese
2013-04-22dma: Add i.MX6 support to drivers/dma/apbh_dma.cStefan Roese
2013-04-22imx: Move some i.MX common functions into the imx-common directoryStefan Roese
2013-04-22mx6: Add solo-lite variant supportFabio Estevam
2013-04-22iomux-v3: Place pad control definitions into common fileFabio Estevam
2013-04-13spi: mxc_spi: Set master mode for all channelsFabio Estevam
2013-03-20Add initial support for Wandboard dual lite and solo.Fabio Estevam
2013-03-07mx6: Provide a structure for accessing HDMI registersFabio Estevam
2013-03-07i.MX6: Add DDR controller registersEric Nelson
2013-03-07i.MX6DL: define IOMUX pads NANDF_CS1-3 for use as GPIOEric Nelson
2013-03-07i.MX6: crm_regs: define IOMUXC_GPR4/6/7Eric Nelson
2013-03-07i.MX6: crm_regs: define CCM_CCGRx for use in board config filesEric Nelson
2013-03-07i.MX6: consolidate pad names for multi-CPU boardsEric Nelson
2013-02-12mx6: Disable Power Down Bit of watchdogFabio Estevam
2012-11-10arch-mx6: add mx6dl_pins.hTroy Kisky
2012-11-10imx-common: cpu: add imx_ddr_sizeTroy Kisky
2012-11-10mx6: soc: update get_cpu_rev and get_imx_type for mx6solo/sololiteTroy Kisky
2012-10-16i.MX6: add HDMI transmitter register declarations from kernel WIP.Eric Nelson
2012-10-16i.MX6: set drive strength for parallel RGB padsEric Nelson
2012-10-16mx6qsabreauto: Pass the board revision to the kernelFabio Estevam
2012-10-15mx5/6: Define default SoC input clock frequenciesBenoît Thébaudeau
2012-10-15imx: Use MXC_I2C_CLK in imx i2c driverMatthias Weisser
2012-10-15i.MX6: get rid of redundant struct src_regs (dupe of struct src)Eric Nelson
2012-10-15i.MX6: define struct iomuxc and IOMUX_GPR2 register bitfieldsEric Nelson
2012-10-15i.MX6: Add ANATOP_PFD_480 bitfield constantsEric Nelson
2012-10-15i.MX6: define IOMUX_GPR3 register bitfieldsEric Nelson
2012-10-15i.MX6: define bitfields for CHSCCDR registerEric Nelson
2012-10-15i.MX6: change register name for CCM_CHSCCDR to match ref. manualEric Nelson
2012-10-15i.MX6: provide functional names for CCM_CCGR0-CCGR6 bit fieldsEric Nelson
2012-09-17MX6: drop binary constants from iomux headerStefano Babic
2012-09-01mxc: Define architecture identifierBenoît Thébaudeau
2012-09-01MX: Set a common gpio.h for all i.MXStefano Babic
2012-09-01imx-common/cmd_bmode.c: add imx bmode (bootmode) commandTroy Kisky
2012-09-01iomux: move IOMUX_GPR13_xxx definesTroy Kisky
2012-07-31imx-common: add i2c.c for bus recovery supportTroy Kisky
2012-07-31i.mx: iomux-v3.h: move to imx-common include directoryTroy Kisky
2012-07-20mx6: Make pad name macro consistent with the datasheetAshok
2012-07-10mx6: Allow mx6 to access the IPUv3 registersFabio Estevam
2012-07-07i.mx: i.mx6x: NO_MUX_I/NO_PAD_I not set correctlyJason Liu
2012-05-15i.MX6: add enable_sata_clock()Eric Nelson
2012-05-15i.MX6: Add ANATOP regulator initDirk Behme
2012-05-15imx-common: Factor out get_ahb_clk()Fabio Estevam
2012-04-16imx: Remove unneeded/repititive definitions from imx headersVikram Narayanan