uboot-2021-rebase.git - uboot 2021 rebase, to fix booting on modern SD cards, from https://github.com/fifteenhex/u-boot/tree/am335x_som

Age	Commit message (Expand)	Author
2012-05-15	i.MX6: Add ANATOP regulator init	Dirk Behme
2012-05-15	mx53loco: Allow to print CPU information at a later stage	Fabio Estevam
2012-05-15	mx5: Add clock config interface	Fabio Estevam
2012-05-15	imx-common: Factor out get_ahb_clk()	Fabio Estevam
2012-05-15	MX53: add function to set SATA clock to internal	Stefano Babic
2012-05-15	MX5: Add definitions for SATA controller	Stefano Babic
2012-05-15	Define UART4 and UART5 base addresses	Stefano Babic
2012-05-15	EXYNOS: support EXYNOS MIPI DSI interface driver.	Donghwa Lee
2012-05-15	EXYNOS: support EXYNOS framebuffer and FIMD display drivers.	Donghwa Lee
2012-05-15	EXYNOS: add LCD and MIPI DSI clock interface.	Donghwa Lee
2012-05-15	EXYNOS: definitions of system resgister and power management registers.	Donghwa Lee
2012-05-15	EXYNOS: Rename exynos5_tzpc structure to exynos_tzpc	Chander Kashyap
2012-05-15	OMAP3: pandora: pin mux updates for DM3730 board variant	Grazvydas Ignotas
2012-05-15	omap4+: Avoid using __attribute__ ((__packed__))	Aneesh V
2012-05-15	arm: adapt asm/linkage.h from Linux	Aneesh V
2012-05-15	OMAP3+: reset: Create a common reset layer.	SRICHARAN R
2012-05-15	omap5: pbias ldo9 turn on	Balaji T K
2012-05-15	arm: omap5: correct boot device mode7 for eMMC	Balaji T K
2012-05-15	OMAP4/5: emif: Correct the emif power mgt shadow register bit fields.	SRICHARAN R
2012-05-15	OMAP4/5: device: Add support to get the device type.	SRICHARAN R
2012-05-15	OMAP4/5: Make the sysctrl structure common	SRICHARAN R
2012-05-15	OMAP5: SRAM: Change the SRAM base address.	SRICHARAN R
2012-05-15	OMAP4/5: Make the silicon revision variable common.	SRICHARAN R
2012-05-15	OMAP5: palmas: Configure nominal opp vdd values	SRICHARAN R
2012-05-15	OMAP5: emif/ddr: Change emif settings as required for ES1.0 silicon.	SRICHARAN R
2012-05-15	OMAP5: io: Configure the io settings for omap5430 sevm board.	SRICHARAN R
2012-05-15	OMAP5: board: Add pinmux data for omap5_evm board.	SRICHARAN R
2012-05-15	OMAP5: clocks: Change clock settings as required for ES1.0 silicon.	SRICHARAN R
2012-05-15	OMAP4460: TPS Ensure SET1 is selected after voltage configuration	Nishanth Menon
2012-05-15	OMAP3+: Introduce generic logic for OMAP voltage controller	Nishanth Menon
2012-05-15	ARM:OMAP+:MMC: Add parameters to MMC init	Jonathan Solnit
2012-05-15	serial: add LPC32X0 high-speed UART devices support	Vladimir Zapolskiy
2012-05-15	arm926ejs: add NXP LPC32x0 cpu series support	Vladimir Zapolskiy
2012-04-24	i2c: Add support for designware i2c controller	Vipin KUMAR
2012-04-16	DMA: Split the APBH DMA init into block and channel init	Marek Vasut
2012-04-16	imx: Remove unneeded/repititive definitions from imx headers	Vikram Narayanan
2012-04-16	i.MX6: define CACHELINE_SIZE	Eric Nelson
2012-03-29	tegra: i2c: Add I2C driver	Yen Lin
2012-03-29	tegra: Enhance clock support to handle 16-bit clock divisors	Simon Glass
2012-03-29	tegra: Rename NV_PA_PMC_BASE to TEGRA2_PMC_BASE	Simon Glass
2012-03-29	tegra: usb: Add support for Tegra USB peripheral	Simon Glass
2012-03-29	tegra: fdt: Add function to return peripheral/clock ID	Simon Glass
2012-03-27	EXYNOS: Add structure for Exynos4 DMC	Chander Kashyap
2012-03-27	arm: Add Prep subcommand support to bootm	Simon Schwarz
2012-03-27	omap-common/spl: Add linux boot to SPL	Simon Schwarz
2012-03-27	devkit8000/spl: init GPMC for dm9000 in SPL	Simon Schwarz
2012-03-27	mx6: Read silicon revision from register	Fabio Estevam
2012-03-27	mx6: Remove duplicate definition of ANATOP_BASE_ADDR	Fabio Estevam
2012-03-26	IXP: Fix GPIO_INT_ACT_LOW_SET()	Marek Vasut
2012-03-26	SPL: Add YMODEM over UART load support	Matt Porter