summaryrefslogtreecommitdiff
path: root/board/ti
AgeCommit message (Expand)Author
2017-03-20ARM: k2g: setup PRU ethernet MAC addressesRoger Quadros
2017-03-20ARM: Use Kconfig for board EEPROM's I2C bus and chip addressRoger Quadros
2017-03-20board: ti: am57xx-idk: Auto detect LCD PanelNishanth Menon
2017-03-20board: ti: am571x-idk: Update pinmux for ICSS2 EthernetRoger Quadros
2017-03-20board: ti: am571x-idk: Support 6 port Ethernet or 4 port Ethernet with LCDRoger Quadros
2017-03-20ti: common: board_detect: commodify ethaddr environment setting codeRoger Quadros
2017-03-20ti: common: board_detect: Rename EEPROM scratch start macroLokesh Vutla
2017-03-19ti: boot: Register the MMC controllers in SPL in the same way as in u-bootJean-Jacques Hiblot
2017-03-09TI: Migrate board/ti/common/Kconfig to implyTom Rini
2017-03-09am335x_evm: Switch to using imply keywordTom Rini
2017-02-17arm: am57xx: Set serial# variableSemen Protsenko
2017-01-28Revert "arm: Remove unregister MACH_TYPE_xxx uses"Tom Rini
2017-01-21status_led: Kconfig migrationUri Mashiach
2017-01-20serial, ns16550: bugfix: ns16550 fifo not enabledHeiko Schocher
2017-01-14arm: Remove unregister MACH_TYPE_xxx usesTom Rini
2016-12-09arm: am33xx: Initialize EMIF REG_PR_OLD_COUNT for BBB and am335x-evmJyri Sarha
2016-12-09am57xx: Set tps659038 PMIC GPIO7 pad mux value to POWERHOLDKeerthy
2016-12-05ARM: DRA7: AMxx: Make sure that the SPL always reads the configuration EEPROMJean-Jacques Hiblot
2016-12-04ARM: dts: AM571x-IDK Initial SupportSchuyler Patton
2016-12-04board: ti: am57xx: Add support for the am571x idkSteve Kipisz
2016-12-04board: ti: am572x-idk: Update pinmux using latest PMTLokesh Vutla
2016-12-04board: ti: am572x: Add pinmux for X15/GPEVM SR2.0 using latest PMTNishanth Menon
2016-12-04board: ti: am57xx: Update SR1.1 RGMII0 iodelay timings for x15/GPEVMNishanth Menon
2016-12-04board: ti: am57xx: Add support for detection of X15 revb1Lokesh Vutla
2016-12-04board: ti: am57xx: Add support for detection of reva3 variations for GPEVMNishanth Menon
2016-12-04ARM: dts: dra71x-evm: Add DT supportLokesh Vutla
2016-12-04board: ti: dra71x-evm: Add PMIC supportKeerthy
2016-12-04board: ti: dra72: Introduce optimization for rgmii timing for rev CNishanth Menon
2016-12-04board: ti: dra71x-evm: Add mux settingsLokesh Vutla
2016-12-04board: ti: dra71x-evm: Add epprom supportLokesh Vutla
2016-12-04ARM: OMAP4+: Add support for dynamically selecting OPPsLokesh Vutla
2016-12-03board: ti: am57xx: add FIT image TEE processingAndrew F. Davis
2016-12-03board: ti: dra7xx: add FIT image TEE processingAndrew F. Davis
2016-12-03ARM: AMx3xx: Make FIT boot as default boot on HS devicesLokesh Vutla
2016-12-03ARM: AM57xx: Make FIT boot as default boot on HS devicesLokesh Vutla
2016-12-03ARM: DRA7: Make FIT boot as default boot on HS devicesLokesh Vutla
2016-11-28keystone2: Move target selection to KconfigAndrew F. Davis
2016-11-21am57xx: Remove unused variable warningsTom Rini
2016-11-21board: ti: amx3xx: Remove multiple EEPROM readsLokesh Vutla
2016-11-13ARM: k2g: Update PLL Multiplier and divider valuesLokesh Vutla
2016-11-13board: am335x/mux: Do not hang when encountering a bad EEPROMAlex G
2016-10-31ti: common: board_detect: Return a valid empty string for un-initialized eepromNishanth Menon
2016-10-31ti: common: board_detect: Setup initial default value for config as wellNishanth Menon
2016-10-31ti: common: board_detect: Replace hardcoded value with macroNishanth Menon
2016-10-13board: am335x: Always set eth/eth1addr environment variableRoger Quadros
2016-10-13board: am335x-icev2: add ethernet phy mode detection logicRoger Quadros
2016-10-08board: ti: dra7xx: complex definitions should be protected with parenthesesMugunthan V N
2016-10-08ARM: dts: dra72: add rev C evm supportMugunthan V N
2016-10-02board: am33xx-hs: Allow post-processing of FIT image on AM33xxAndrew F. Davis
2016-10-01board: ks2: Enable ECC using detected DDR sizeLokesh Vutla
generated by cgit (git 2.34.1) at 2024-12-25 19:44:37 +0000