1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
|
// SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
/*
* Copyright (C) 2018, STMicroelectronics - All Rights Reserved
*/
#include <common.h>
#include <dm.h>
#include <asm/io.h>
#include <asm/arch/ddr.h>
#include <power/pmic.h>
#include <power/stpmic1.h>
#ifdef CONFIG_DEBUG_UART_BOARD_INIT
void board_debug_uart_init(void)
{
#if (CONFIG_DEBUG_UART_BASE == STM32_UART4_BASE)
#define RCC_MP_APB1ENSETR (STM32_RCC_BASE + 0x0A00)
#define RCC_MP_AHB4ENSETR (STM32_RCC_BASE + 0x0A28)
/* UART4 clock enable */
setbits_le32(RCC_MP_APB1ENSETR, BIT(16));
#define GPIOG_BASE 0x50008000
/* GPIOG clock enable */
writel(BIT(6), RCC_MP_AHB4ENSETR);
/* GPIO configuration for EVAL board
* => Uart4 TX = G11
*/
writel(0xffbfffff, GPIOG_BASE + 0x00);
writel(0x00006000, GPIOG_BASE + 0x24);
#else
#error("CONFIG_DEBUG_UART_BASE: not supported value")
#endif
}
#endif
#ifdef CONFIG_PMIC_STPMIC1
int board_ddr_power_init(void)
{
struct udevice *dev;
int ret;
ret = uclass_get_device_by_driver(UCLASS_PMIC,
DM_GET_DRIVER(pmic_stpmic1), &dev);
if (ret)
/* No PMIC on board */
return 0;
/* VTT = Set LDO3 to sync mode */
ret = pmic_reg_read(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3));
if (ret < 0)
return ret;
ret &= ~STPMIC1_LDO3_MODE;
ret &= ~STPMIC1_LDO12356_VOUT_MASK;
ret |= STPMIC1_LDO_VOUT(STPMIC1_LDO3_DDR_SEL);
ret = pmic_reg_write(dev, STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3),
ret);
if (ret < 0)
return ret;
/* VDD_DDR = Set BUCK2 to 1.35V */
ret = pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK2),
STPMIC1_BUCK_VOUT_MASK,
STPMIC1_BUCK2_1350000V);
if (ret < 0)
return ret;
/* Enable VDD_DDR = BUCK2 */
ret = pmic_clrsetbits(dev,
STPMIC1_BUCKX_MAIN_CR(STPMIC1_BUCK2),
STPMIC1_BUCK_ENA, STPMIC1_BUCK_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
/* Enable VREF */
ret = pmic_clrsetbits(dev, STPMIC1_REFDDR_MAIN_CR,
STPMIC1_VREF_ENA, STPMIC1_VREF_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
/* Enable LDO3 */
ret = pmic_clrsetbits(dev,
STPMIC1_LDOX_MAIN_CR(STPMIC1_LDO3),
STPMIC1_LDO_ENA, STPMIC1_LDO_ENA);
if (ret < 0)
return ret;
mdelay(STPMIC1_DEFAULT_START_UP_DELAY_MS);
return 0;
}
#endif
|
