blob: 73836ada094be2ed0f94cf033069001b90de71ad (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
|
config BLK
bool "Support block devices"
depends on DM
default y if DM_MMC
help
Enable support for block devices, such as SCSI, MMC and USB
flash sticks. These provide a block-level interface which permits
reading, writing and (in some cases) erasing blocks. Block
devices often have a partition table which allows the device to
be partitioned into several areas, called 'partitions' in U-Boot.
A filesystem can be placed in each partition.
config HAVE_BLOCK_DEVICE
bool "Enable Legacy Block Device"
help
Some devices require block support whether or not DM is enabled
config SPL_BLK
bool "Support block devices in SPL"
depends on SPL_DM && BLK
default y
help
Enable support for block devices, such as SCSI, MMC and USB
flash sticks. These provide a block-level interface which permits
reading, writing and (in some cases) erasing blocks. Block
devices often have a partition table which allows the device to
be partitioned into several areas, called 'partitions' in U-Boot.
A filesystem can be placed in each partition.
config BLOCK_CACHE
bool "Use block device cache"
default n
help
This option enables a disk-block cache for all block devices.
This is most useful when accessing filesystems under U-Boot since
it will prevent repeated reads from directory structures and other
filesystem data structures.
config IDE
bool "Support IDE controllers"
select HAVE_BLOCK_DEVICE
help
Enables support for IDE (Integrated Drive Electronics) hard drives.
This allows access to raw blocks and filesystems on an IDE drive
from U-Boot. See also CMD_IDE which provides an 'ide' command for
performing various IDE operations.
config SYSTEMACE
bool "Xilinx SystemACE support"
select HAVE_BLOCK_DEVICE
help
Adding this option adds support for Xilinx SystemACE chips attached
via some sort of local bus. The address of the chip must also be
defined in the CONFIG_SYS_SYSTEMACE_BASE macro.
When SystemACE support is added, the "ace" device type becomes
available to the fat commands, i.e. fatls.
config SYS_SYSTEMACE_BASE
hex "Base address of SystemACE chip"
depends on SYSTEMACE
config SYS_SYSTEMACE_WIDTH
int "Word size of access to the of SystemACE chip"
depends on SYSTEMACE
|
