1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
|
// SPDX-License-Identifier: GPL-2.0+
/*
* Meson GXL USB3 PHY driver
*
* Copyright (C) 2018 Martin Blumenstingl <martin.blumenstingl@googlemail.com>
* Copyright (C) 2018 BayLibre, SAS
* Author: Neil Armstrong <narmstron@baylibre.com>
*/
#include <common.h>
#include <malloc.h>
#include <asm/io.h>
#include <bitfield.h>
#include <dm.h>
#include <errno.h>
#include <generic-phy.h>
#include <regmap.h>
#include <clk.h>
#include <linux/usb/otg.h>
#include <asm/arch/usb-gx.h>
#include <linux/bitops.h>
#include <linux/compat.h>
#include <linux/bitfield.h>
#define USB_R0 0x00
#define USB_R0_P30_FSEL_MASK GENMASK(5, 0)
#define USB_R0_P30_PHY_RESET BIT(6)
#define USB_R0_P30_TEST_POWERDOWN_HSP BIT(7)
#define USB_R0_P30_TEST_POWERDOWN_SSP BIT(8)
#define USB_R0_P30_ACJT_LEVEL_MASK GENMASK(13, 9)
#define USB_R0_P30_TX_BOOST_LEVEL_MASK GENMASK(16, 14)
#define USB_R0_P30_LANE0_TX2RX_LOOPBACK BIT(17)
#define USB_R0_P30_LANE0_EXT_PCLK_REQ BIT(18)
#define USB_R0_P30_PCS_RX_LOS_MASK_VAL_MASK GENMASK(28, 19)
#define USB_R0_U2D_SS_SCALEDOWN_MODE_MASK GENMASK(30, 29)
#define USB_R0_U2D_ACT BIT(31)
#define USB_R1 0x04
#define USB_R1_U3H_BIGENDIAN_GS BIT(0)
#define USB_R1_U3H_PME_ENABLE BIT(1)
#define USB_R1_U3H_HUB_PORT_OVERCURRENT_MASK GENMASK(6, 2)
#define USB_R1_U3H_HUB_PORT_PERM_ATTACH_MASK GENMASK(11, 7)
#define USB_R1_U3H_HOST_U2_PORT_DISABLE_MASK GENMASK(15, 12)
#define USB_R1_U3H_HOST_U3_PORT_DISABLE BIT(16)
#define USB_R1_U3H_HOST_PORT_POWER_CONTROL_PRESENT BIT(17)
#define USB_R1_U3H_HOST_MSI_ENABLE BIT(18)
#define USB_R1_U3H_FLADJ_30MHZ_REG_MASK GENMASK(24, 19)
#define USB_R1_P30_PCS_TX_SWING_FULL_MASK GENMASK(31, 25)
#define USB_R2 0x08
#define USB_R2_P30_CR_DATA_IN_MASK GENMASK(15, 0)
#define USB_R2_P30_CR_READ BIT(16)
#define USB_R2_P30_CR_WRITE BIT(17)
#define USB_R2_P30_CR_CAP_ADDR BIT(18)
#define USB_R2_P30_CR_CAP_DATA BIT(19)
#define USB_R2_P30_PCS_TX_DEEMPH_3P5DB_MASK GENMASK(25, 20)
#define USB_R2_P30_PCS_TX_DEEMPH_6DB_MASK GENMASK(31, 26)
#define USB_R3 0x0c
#define USB_R3_P30_SSC_ENABLE BIT(0)
#define USB_R3_P30_SSC_RANGE_MASK GENMASK(3, 1)
#define USB_R3_P30_SSC_REF_CLK_SEL_MASK GENMASK(12, 4)
#define USB_R3_P30_REF_SSP_EN BIT(13)
#define USB_R3_P30_LOS_BIAS_MASK GENMASK(18, 16)
#define USB_R3_P30_LOS_LEVEL_MASK GENMASK(23, 19)
#define USB_R3_P30_MPLL_MULTIPLIER_MASK GENMASK(30, 24)
#define USB_R4 0x10
#define USB_R4_P21_PORT_RESET_0 BIT(0)
#define USB_R4_P21_SLEEP_M0 BIT(1)
#define USB_R4_MEM_PD_MASK GENMASK(3, 2)
#define USB_R4_P21_ONLY BIT(4)
#define USB_R5 0x14
#define USB_R5_ID_DIG_SYNC BIT(0)
#define USB_R5_ID_DIG_REG BIT(1)
#define USB_R5_ID_DIG_CFG_MASK GENMASK(3, 2)
#define USB_R5_ID_DIG_EN_0 BIT(4)
#define USB_R5_ID_DIG_EN_1 BIT(5)
#define USB_R5_ID_DIG_CURR BIT(6)
#define USB_R5_ID_DIG_IRQ BIT(7)
#define USB_R5_ID_DIG_TH_MASK GENMASK(15, 8)
#define USB_R5_ID_DIG_CNT_MASK GENMASK(23, 16)
/* read-only register */
#define USB_R6 0x18
#define USB_R6_P30_CR_DATA_OUT_MASK GENMASK(15, 0)
#define USB_R6_P30_CR_ACK BIT(16)
struct phy_meson_gxl_usb3_priv {
struct regmap *regmap;
#if CONFIG_IS_ENABLED(CLK)
struct clk clk;
#endif
};
void phy_meson_gxl_usb3_set_mode(struct phy *phy, enum usb_dr_mode mode)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
switch (mode) {
case USB_DR_MODE_UNKNOWN:
case USB_DR_MODE_HOST:
case USB_DR_MODE_OTG:
regmap_read(priv->regmap, USB_R0, &val);
val &= ~USB_R0_U2D_ACT;
regmap_write(priv->regmap, USB_R0, val);
regmap_read(priv->regmap, USB_R4, &val);
val &= ~USB_R4_P21_SLEEP_M0;
regmap_write(priv->regmap, USB_R4, val);
break;
case USB_DR_MODE_PERIPHERAL:
regmap_read(priv->regmap, USB_R0, &val);
val |= USB_R0_U2D_ACT;
regmap_write(priv->regmap, USB_R0, val);
regmap_read(priv->regmap, USB_R4, &val);
val |= USB_R4_P21_SLEEP_M0;
regmap_write(priv->regmap, USB_R4, val);
break;
}
}
static int phy_meson_gxl_usb3_power_on(struct phy *phy)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
regmap_read(priv->regmap, USB_R5, &val);
val |= USB_R5_ID_DIG_EN_0;
val |= USB_R5_ID_DIG_EN_1;
val &= ~USB_R5_ID_DIG_TH_MASK;
val |= FIELD_PREP(USB_R5_ID_DIG_TH_MASK, 0xff);
regmap_write(priv->regmap, USB_R5, val);
phy_meson_gxl_usb3_set_mode(phy, USB_DR_MODE_HOST);
return 0;
}
static int phy_meson_gxl_usb3_power_off(struct phy *phy)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
regmap_read(priv->regmap, USB_R5, &val);
val &= ~USB_R5_ID_DIG_EN_0;
val &= ~USB_R5_ID_DIG_EN_1;
regmap_write(priv->regmap, USB_R5, val);
return 0;
}
static int phy_meson_gxl_usb3_init(struct phy *phy)
{
struct udevice *dev = phy->dev;
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
uint val;
regmap_read(priv->regmap, USB_R1, &val);
val &= ~USB_R1_U3H_FLADJ_30MHZ_REG_MASK;
val |= FIELD_PREP(USB_R1_U3H_FLADJ_30MHZ_REG_MASK, 0x20);
regmap_write(priv->regmap, USB_R1, val);
return 0;
}
struct phy_ops meson_gxl_usb3_phy_ops = {
.init = phy_meson_gxl_usb3_init,
.power_on = phy_meson_gxl_usb3_power_on,
.power_off = phy_meson_gxl_usb3_power_off,
};
int meson_gxl_usb3_phy_probe(struct udevice *dev)
{
struct phy_meson_gxl_usb3_priv *priv = dev_get_priv(dev);
int ret;
ret = regmap_init_mem(dev_ofnode(dev), &priv->regmap);
if (ret)
return ret;
#if CONFIG_IS_ENABLED(CLK)
ret = clk_get_by_index(dev, 0, &priv->clk);
if (ret < 0)
return ret;
ret = clk_enable(&priv->clk);
if (ret && ret != -ENOSYS && ret != -ENOTSUPP) {
pr_err("failed to enable PHY clock\n");
clk_free(&priv->clk);
return ret;
}
#endif
return 0;
}
static const struct udevice_id meson_gxl_usb3_phy_ids[] = {
{ .compatible = "amlogic,meson-gxl-usb3-phy" },
{ }
};
U_BOOT_DRIVER(meson_gxl_usb3_phy) = {
.name = "meson_gxl_usb3_phy",
.id = UCLASS_PHY,
.of_match = meson_gxl_usb3_phy_ids,
.probe = meson_gxl_usb3_phy_probe,
.ops = &meson_gxl_usb3_phy_ops,
.priv_auto_alloc_size = sizeof(struct phy_meson_gxl_usb3_priv),
};
|
