blob: 0aee1e1cf6b75863b22faa9b628736772044b0b0 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
|
/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright (C) 2016-2017
* Lukasz Majewski, DENX Software Engineering, lukma@denx.de
*/
#ifndef __CONFIG_H
#define __CONFIG_H
#include "mx6_common.h"
#define CONFIG_SPL_LIBCOMMON_SUPPORT
#include "imx6_spl.h"
#define CONFIG_SYS_UBOOT_BASE (CONFIG_SYS_FLASH_BASE + 0x80000)
#define CONFIG_SYS_SPL_ARGS_ADDR 0x18000000
/*
* Below defines are set but NOT really used since we by
* design force U-Boot run when we boot in development
* mode from SD card (SD2)
*/
#define CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTOR (0x800)
#define CONFIG_SYS_MMCSD_RAW_MODE_ARGS_SECTORS (0x80)
#define CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR (0x1000)
#define CONFIG_SPL_FS_LOAD_KERNEL_NAME "fitImage"
/* Size of malloc() pool */
#define CONFIG_SYS_MALLOC_LEN (10 * SZ_1M)
#define CONFIG_BOARD_LATE_INIT
#define CONFIG_MXC_UART_BASE UART1_BASE
#define CONFIG_SYS_MEMTEST_START 0x10000000
#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MEMTEST_START + 500 * SZ_1M)
/* MMC Configuration */
#define CONFIG_SYS_FSL_USDHC_NUM 2
#define CONFIG_SYS_FSL_ESDHC_ADDR 0
/* NOR 16-bit mode */
#define CONFIG_SYS_FLASH_BASE WEIM_ARB_BASE_ADDR
#define CONFIG_SYS_FLASH_CFI_WIDTH FLASH_CFI_16BIT
#define CONFIG_SYS_FLASH_EMPTY_INFO
#define CONFIG_FLASH_VERIFY
/* NOR Flash MTD */
#define CONFIG_SYS_MAX_FLASH_BANKS_DETECT 1
#define CONFIG_SYS_FLASH_BANKS_LIST { (CONFIG_SYS_FLASH_BASE) }
#define CONFIG_SYS_FLASH_BANKS_SIZES { (32 * SZ_1M) }
/* Ethernet Configuration */
#define IMX_FEC_BASE ENET_BASE_ADDR
#define CONFIG_FEC_MXC_PHYADDR 1
#define CONFIG_EXTRA_ENV_SETTINGS \
"console=ttymxc0,115200 quiet\0" \
"fdt_high=0xffffffff\0" \
"initrd_high=0xffffffff\0" \
"boot_os=yes\0" \
"kernelsize=0x300000\0" \
"disable_giga=yes\0" \
"download_kernel=" \
"tftpboot ${loadaddr} ${kernel_file};\0" \
"get_boot_medium=" \
"setenv boot_medium nor;" \
"setexpr.l _src_sbmr1 *0x020d8004;" \
"setexpr _b_medium ${_src_sbmr1} '&' 0x00000040;" \
"if test ${_b_medium} = 40; then " \
"setenv boot_medium sdcard;" \
"fi\0" \
"kernel_file=fitImage\0" \
"boot_sd=" \
"echo '#######################';" \
"echo '# Factory SDcard Boot #';" \
"echo '#######################';" \
"setenv mmcdev 1;" \
"setenv mmcfactorydev 0;" \
"setenv mmcfactorypart 1;" \
"run factory_flash_img;\0" \
"boot_nor=" \
"setenv kernelnor 0x08180000;" \
"setenv bootargs console=${console} " \
CONFIG_MTDPARTS_DEFAULT " " \
"root=/dev/mmcblk1 rootfstype=ext4 rw rootwait noinitrd;" \
"cp.l ${kernelnor} ${loadaddr} ${kernelsize};" \
"bootm ${loadaddr};reset;\0" \
"boot_recovery=" \
"echo '#######################';" \
"echo '# RECOVERY SWU Boot #';" \
"echo '#######################';" \
"setenv rootfsloadaddr 0x13000000;" \
"setenv swukernelnor 0x08980000;" \
"setenv swurootfsnor 0x09180000;" \
"setenv bootargs console=${console} " \
CONFIG_MTDPARTS_DEFAULT " " \
"ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}" \
":${hostname}::off root=/dev/ram rw;" \
"cp.l ${swurootfsnor} ${rootfsloadaddr} 0x200000;" \
"cp.l ${swukernelnor} ${loadaddr} ${kernelsize};" \
"bootm ${loadaddr} ${rootfsloadaddr};reset;\0" \
"boot_tftp=" \
"echo '#######################';" \
"echo '# TFTP Boot #';" \
"echo '#######################';" \
"if run download_kernel; then " \
"setenv bootargs console=${console} " \
"root=/dev/mmcblk0p2 rootwait;" \
"bootm $loadaddr};reset;" \
"fi\0" \
"bootcmd=" \
"if test -n ${recovery_status}; then " \
"run boot_recovery;" \
"else " \
"if test ! -n ${boot_medium}; then " \
"run get_boot_medium;" \
"if test ${boot_medium} = sdcard; then " \
"run boot_sd;" \
"else " \
"run boot_nor;" \
"fi;" \
"else " \
"if test ${boot_medium} = tftp; then " \
"run boot_tftp;" \
"fi;" \
"fi;" \
"fi\0" \
"mtdparts=" CONFIG_MTDPARTS_DEFAULT "\0" \
"bootdev=1\0" \
"bootpart=1\0" \
"netdev=eth0\0" \
"load_addr=0x11000000\0" \
"uboot_file=u-boot.img\0" \
"SPL_file=SPL\0" \
"load_uboot=tftp ${load_addr} ${uboot_file}\0" \
"nor_img_addr=0x11000000\0" \
"nor_img_file=core-image-lwn-mccmon6.nor\0" \
"emmc_img_file=core-image-lwn-mccmon6.ext4\0" \
"nor_bank_start=" __stringify(CONFIG_SYS_FLASH_BASE) "\0" \
"nor_img_size=0x02000000\0" \
"factory_script_file=factory.scr\0" \
"factory_load_script=" \
"if test -e mmc ${mmcdev}:${mmcfactorypart} " \
"${factory_script_file}; then " \
"load mmc ${mmcdev}:${mmcfactorypart} " \
"${loadaddr} ${factory_script_file};" \
"fi\0" \
"factory_script=echo Running factory script from mmc${mmcdev} ...; " \
"source ${loadaddr}\0" \
"factory_flash_img="\
"echo 'Flash mccmon6 with factory images'; " \
"if run factory_load_script; then " \
"run factory_script;" \
"else " \
"echo No factory script: ${factory_script_file} found on " \
"device ${mmcdev};" \
"run factory_nor_img;" \
"run factory_eMMC_img;" \
"run factory_SPL_falcon_setup;" \
"fi\0" \
"factory_eMMC_img="\
"echo 'Update mccmon6 eMMC image'; " \
"if load mmc ${mmcdev}:${mmcfactorypart} " \
"${loadaddr} ${emmc_img_file}; then " \
"setexpr fw_sz ${filesize} / 0x200;" \
"setexpr fw_sz ${fw_sz} + 1;" \
"mmc dev ${mmcfactorydev};" \
"mmc write ${loadaddr} 0x0 ${fw_sz};" \
"fi\0" \
"factory_nor_img="\
"echo 'Update mccmon6 NOR image'; " \
"if load mmc ${mmcdev}:${mmcfactorypart} " \
"${nor_img_addr} ${nor_img_file}; then " \
"run nor_update;" \
"fi\0" \
"nor_update=" \
"protect off ${nor_bank_start} +${nor_img_size};" \
"erase ${nor_bank_start} +${nor_img_size};" \
"setexpr nor_img_size ${nor_img_size} / 4; " \
"cp.l ${nor_img_addr} ${nor_bank_start} ${nor_img_size}\0" \
"factory_SPL_falcon_setup="\
"echo 'Write Falcon boot data'; " \
"setenv kernelnor 0x08180000;" \
"cp.l ${kernelnor} ${loadaddr} ${kernelsize};" \
"spl export fdt ${loadaddr};" \
"setenv nor_img_addr ${fdtargsaddr};" \
"setenv nor_img_size 0x20000;" \
"setenv nor_bank_start " \
__stringify(CONFIG_CMD_SPL_NOR_OFS)";" \
"run nor_update\0" \
"tftp_nor_uboot="\
"echo 'Update mccmon6 NOR U-BOOT via TFTP'; " \
"setenv nor_img_file u-boot.img; " \
"setenv nor_img_size 0x80000; " \
"setenv nor_bank_start 0x08080000; " \
"if tftpboot ${nor_img_addr} ${nor_img_file}; then " \
"run nor_update;" \
"fi\0" \
"tftp_nor_fitImg="\
"echo 'Update mccmon6 NOR fitImage via TFTP'; " \
"setenv nor_img_file fitImage; " \
"setenv nor_img_size 0x500000; " \
"setenv nor_bank_start 0x08180000; " \
"if tftpboot ${nor_img_addr} ${nor_img_file}; then " \
"run nor_update;" \
"fi\0" \
"tftp_nor_img="\
"echo 'Update mccmon6 NOR image via TFTP'; " \
"if tftpboot ${nor_img_addr} ${nor_img_file}; then " \
"run nor_update;" \
"fi\0" \
"tftp_nor_SPL="\
"if tftp ${load_addr} SPL_padded; then " \
"erase 0x08000000 +0x20000;" \
"cp.b ${load_addr} 0x08000000 0x20000;" \
"fi;\0" \
"tftp_sd_SPL="\
"if mmc dev 1; then " \
"if tftp ${load_addr} ${SPL_file}; then " \
"setexpr fw_sz ${filesize} / 0x200; " \
"setexpr fw_sz ${fw_sz} + 1; " \
"mmc write ${load_addr} 0x2 ${fw_sz};" \
"fi;" \
"fi;\0" \
"tftp_sd_uboot="\
"if mmc dev 1; then " \
"if run load_uboot; then " \
"setexpr fw_sz ${filesize} / 0x200; " \
"setexpr fw_sz ${fw_sz} + 1; " \
"mmc write ${load_addr} 0x8A ${fw_sz};" \
"fi;" \
"fi;\0"
/* Physical Memory Map */
#define PHYS_SDRAM MMDC0_ARB_BASE_ADDR
#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM
#define CONFIG_SYS_INIT_RAM_ADDR IRAM_BASE_ADDR
#define CONFIG_SYS_INIT_RAM_SIZE IRAM_SIZE
#define CONFIG_SYS_INIT_SP_OFFSET \
(CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
#define CONFIG_SYS_INIT_SP_ADDR \
(CONFIG_SYS_INIT_RAM_ADDR + CONFIG_SYS_INIT_SP_OFFSET)
/* Environment organization */
/* Envs are stored in NOR flash */
#endif /* __CONFIG_H * */
|
