sh: ap_sh4a_4a: Remove the board

Last change to this board was done in 2016, has no prospects of
ever being converted to DM, drop it.

Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>
Cc: Chris Brandt <chris.brandt@renesas.com>
Cc: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Cc: Vladimir Zapolskiy <vz@mleia.com>
Cc: Yoshihiro Shimoda <shimoda.yoshihiro.uh@renesas.com>

1 files changed, 0 insertions, 102 deletions

diff --git a/include/configs/ap_sh4a_4a.h b/include/configs/ap_sh4a_4a.h
deleted file mode 100644
index edcc0cbc8a..0000000000
--- a/include/configs/ap_sh4a_4a.h
+++ /dev/null
@@ -1,102 +0,0 @@
-/* SPDX-License-Identifier: GPL-2.0+ */
-/*
- * Configuation settings for the Alpha Project AP-SH4A-4A board
- *
- * Copyright (C) 2012 Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
- */
-
-#ifndef __AP_SH4A_4A_H
-#define __AP_SH4A_4A_H
-
-#define CONFIG_CPU_SH7734	1
-#define CONFIG_400MHZ_MODE	1
-
-#define CONFIG_DISPLAY_BOARDINFO
-#undef  CONFIG_SHOW_BOOT_PROGRESS
-
-/* Ether */
-#define CONFIG_SH_ETHER_USE_PORT (0)
-#define CONFIG_SH_ETHER_PHY_ADDR (0x0)
-#define CONFIG_SH_ETHER_PHY_MODE (PHY_INTERFACE_MODE_GMII)
-#define CONFIG_SH_ETHER_SH7734_MII (0x02) /* GMII */
-#define CONFIG_BITBANGMII
-#define CONFIG_BITBANGMII_MULTI
-
-/* undef to save memory	*/
-/* Monitor Command Prompt */
-/* Buffer size for Console output */
-#define CONFIG_SYS_PBSIZE		256
-/* List of legal baudrate settings for this board */
-#define CONFIG_SYS_BAUDRATE_TABLE	{ 115200 }
-
-/* SCIF */
-#define CONFIG_SCIF			1
-#define CONFIG_CONS_SCIF4	1
-
-/* Suppress display of console information at boot */
-
-/* SDRAM */
-#define CONFIG_SYS_SDRAM_BASE	(0x88000000)
-#define CONFIG_SYS_SDRAM_SIZE	(64 * 1024 * 1024)
-#define CONFIG_SYS_LOAD_ADDR	(CONFIG_SYS_SDRAM_BASE + 16 * 1024 * 1024)
-
-#define CONFIG_SYS_MEMTEST_START (CONFIG_SYS_SDRAM_BASE)
-#define CONFIG_SYS_MEMTEST_END	 (CONFIG_SYS_MEMTEST_START + CONFIG_SYS_SDRAM_SIZE)
-/* Enable alternate, more extensive, memory test */
-/* Scratch address used by the alternate memory test */
-#undef  CONFIG_SYS_MEMTEST_SCRATCH
-
-/* Enable temporary baudrate change while serial download */
-#undef  CONFIG_SYS_LOADS_BAUD_CHANGE
-
-/* FLASH */
-#undef  CONFIG_SYS_FLASH_QUIET_TEST
-#define CONFIG_SYS_FLASH_EMPTY_INFO
-#define CONFIG_SYS_FLASH_BASE	(0xA0000000)
-#define CONFIG_SYS_MAX_FLASH_SECT	512
-
-/* if you use all NOR Flash , you change dip-switch. Please see Manual. */
-#define CONFIG_SYS_MAX_FLASH_BANKS	1
-#define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE }
-
-/* Timeout for Flash erase operations (in ms) */
-#define CONFIG_SYS_FLASH_ERASE_TOUT	(3 * 1000)
-/* Timeout for Flash write operations (in ms) */
-#define CONFIG_SYS_FLASH_WRITE_TOUT	(3 * 1000)
-/* Timeout for Flash set sector lock bit operations (in ms) */
-#define CONFIG_SYS_FLASH_LOCK_TOUT	(3 * 1000)
-/* Timeout for Flash clear lock bit operations (in ms) */
-#define CONFIG_SYS_FLASH_UNLOCK_TOUT	(3 * 1000)
-
-/*
- * Use hardware flash sectors protection instead
- * of U-Boot software protection
- */
-#undef  CONFIG_SYS_DIRECT_FLASH_TFTP
-
-/* Address of u-boot image in Flash (NOT run time address in SDRAM) ?!? */
-#define CONFIG_SYS_MONITOR_BASE	(CONFIG_SYS_FLASH_BASE)
-/* Monitor size */
-#define CONFIG_SYS_MONITOR_LEN	(256 * 1024)
-/* Size of DRAM reserved for malloc() use */
-#define CONFIG_SYS_MALLOC_LEN	(256 * 1024)
-#define CONFIG_SYS_BOOTMAPSZ	(8 * 1024 * 1024)
-
-/* ENV setting */
-#define CONFIG_ENV_OVERWRITE	1
-#define CONFIG_ENV_SECT_SIZE	(128 * 1024)
-#define CONFIG_ENV_SIZE		(CONFIG_ENV_SECT_SIZE)
-#define CONFIG_ENV_ADDR		(CONFIG_SYS_FLASH_BASE + CONFIG_SYS_MONITOR_LEN)
-/* Offset of env Flash sector relative to CONFIG_SYS_FLASH_BASE */
-#define CONFIG_ENV_OFFSET	(CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE)
-#define CONFIG_ENV_SIZE_REDUND	(CONFIG_ENV_SECT_SIZE)
-
-/* Board Clock */
-#if defined(CONFIG_400MHZ_MODE)
-#define CONFIG_SYS_CLK_FREQ 50000000
-#else
-#define CONFIG_SYS_CLK_FREQ 44444444
-#endif
-#define CONFIG_SH_SCIF_CLK_FREQ CONFIG_SYS_CLK_FREQ
-
-#endif	/* __AP_SH4A_4A_H */