summaryrefslogtreecommitdiff
path: root/drivers/net/mvpp2.c
AgeCommit message (Expand)Author
2020-02-05dm: core: Create a new header file for 'compat' featuresSimon Glass
2020-02-05dm: core: Require users of devres to include the headerSimon Glass
2020-01-30net: fix typoFlavio Suligoi
2019-12-15dm: gpio: Allow control of GPIO uclass in SPLSimon Glass
2019-12-09net: mvpp2: use new MVMDIO driverNevo Hed
2019-12-09net: mvpp2: mark phy as invalid in case of missing appropriate driverGrzegorz Jaszczyk
2019-12-09net: mvpp2x: fix traffic stuck after PHY start errorStefan Chulski
2019-12-02common: Move ARM cache operations out of common.hSimon Glass
2019-09-04net: mvpp2: support setting hardware addresses from ethernet coreMatt Pelland
2019-01-24net: mvpp2: mdio device per portBaruch Siach
2019-01-24net: mvpp2: fix lookup of mdio registers base addressBaruch Siach
2018-10-24net: mvpp2: increase PHY reset pulseBaruch Siach
2018-10-24net: mvpp2: fix polarity of PHY reset signalBaruch Siach
2018-10-10net.h: Include linux/if_ether.h to avoid duplicationBin Meng
2018-10-09linux/compat.h: Add netdev_### log macrosBin Meng
2018-03-22net: mvpp2x: add check after callocHeinrich Schuchardt
2018-01-29mvpp2: Fix warning over 32bit vs 64bit targetsTom Rini
2017-08-10net: mvpp2x: Set BM poll size once during priv probeStefan Chulski
2017-08-10net: mvpp2x: remove TX drain from transmit routineStefan Chulski
2017-08-10net: mvpp2x: Set BM pool high addressStefan Chulski
2017-08-10net: mvpp2x: Remove IRQ configuration from U-BootStefan Chulski
2017-08-10net: mvpp2x: remove MBUS configurations from MvPP22 driverStefan Chulski
2017-08-10net: mvpp2x: decrease size of AGGR_TXQ and CPU_DESC_CHUNKStefan Chulski
2017-08-10net: mvpp2x: fix BM configuration overrun issueStefan Chulski
2017-08-10net: mvpp2x: Enable GoP packet padding in TXStefan Chulski
2017-08-10net: mvpp2x: fix phy connected to wrong mdio issueStefan Chulski
2017-08-10net: mvpp2x: Add GPIO configuration supportStefan Chulski
2017-06-02net: mvpp2.c: Enable 10G support for port 0 (SFI)Stefan Chulski
2017-06-01dm: Rename dev_addr..() functionsSimon Glass
2017-05-09net: mvpp2: Add remove function that is called before the OS is startedStefan Roese
2017-03-29net: mvpp2: Remove unreferenced in_use_thresh from struct mvpp2_bm_poolStefan Roese
2017-03-29net: mvpp2: Configure SMI PHY address needed for PHY pollingStefan Roese
2017-03-29net: mvpp2: Enable PHY polling mode on PPv2.2Stefan Roese
2017-03-29net: mvpp2: Add missing PHY_INTERFACE_MODE_RGMII_IDStefan Roese
2017-03-29net: mvpp2: Add GoP and NetC support for port 0 (SFI)Stefan Roese
2017-03-29net: mvpp2: Add GoP and NetC support for ports 2 & 3 (RGMII & SGMII)Stefan Roese
2017-03-29net: mvpp2: Read phy-speed from DT to select between 1GB and 2.5GB SGMIIStefan Roese
2017-03-29net: mvpp2: Restructure probe / init functionsStefan Roese
2017-03-29net: mvpp2: Add RX and TX FIFO configuration for PPv2.2Stefan Roese
2017-03-29net: mvpp2: Handle eth device naming in multi-CP case correctlyStefan Roese
2017-03-29net: mvpp2.c: Clear all buffer / descriptor areas before usageStefan Roese
2017-03-29net: mvpp2: Move probe function from MISC to ETH DM driverStefan Roese
2017-03-29net: mvpp2: Add MDIO support for PPv2.2Stefan Roese
2017-03-29net: mvpp2: finally add the PPv2.2 compatible stringThomas Petazzoni
2017-03-29net: mvpp2: adapt rxq distribution to PPv2.2Thomas Petazzoni
2017-03-29net: mvpp2: rework RXQ interrupt group initialization for PPv2.2Thomas Petazzoni
2017-03-29net: mvpp2: add AXI bridge initialization for PPv2.2Thomas Petazzoni
2017-03-29net: mvpp2: handle misc PPv2.1/PPv2.2 differencesThomas Petazzoni
2017-03-29net: mvpp2: handle register mapping and access for PPv2.2Thomas Petazzoni
2017-03-29net: mvpp2: adjust mvpp2_{rxq,txq}_init for PPv2.2Thomas Petazzoni